10-26-2013, 12:40 PM | #1 |
Drives: 2011 CGM Camaro LS A6 Join Date: Jan 2011
Location: San Antonio, Texas
Posts: 10,305
|
Quick question
Does anybody know the diameter of the cats that come with the bbk headers? I'm looking for some cats for my pacesetter headers and I found someone selling the bbk cats for 50 dollars. Just wanted to know if anybody knew if they'd fit
|
10-26-2013, 01:08 PM | #3 |
Drives: 2011 CGM Camaro LS A6 Join Date: Jan 2011
Location: San Antonio, Texas
Posts: 10,305
|
The diameter of the part that lines up to the header. The part that lines up to the exhaust should be 2.5" if I'm not mistaken
|
10-26-2013, 01:15 PM | #4 |
Drives: 2018 Hot Red ZL1 Join Date: Nov 2010
Location: Los Angeles, CA
Posts: 3,599
|
I think that its gonna be tricky because the part that lines up to the header is kinda like a round ending that going into the headers end.. so u would need to have the same ending on ur headers for it to work
__________________
|
10-26-2013, 01:17 PM | #5 |
Drives: 2018 Hot Red ZL1 Join Date: Nov 2010
Location: Los Angeles, CA
Posts: 3,599
|
http://www.camaro5.com/forums/showthread.php?t=300593
check my old thread.. the first picture has the cats
__________________
|
10-26-2013, 03:13 PM | #6 |
I have the Pacesetter long tubes and the end of the long tube is 3" and the cats that I
purchased from Pacesetter are actually mid pipes that start at 3" and taper down to 2 1/2".
__________________
Cai Intake, Pacesetter Ceramic Coated 1 7/8 Long Tube Headers and Legato axel back exhaust.
|
|
10-27-2013, 01:17 AM | #7 |
Drives: 2011 CGM Camaro LS A6 Join Date: Jan 2011
Location: San Antonio, Texas
Posts: 10,305
|
Yea, I know the end of the pacesetter header is 3" for sure. I figured the cat would taper down to 2.5" since the cat back is 2.5 and it has to connect. My question was whether the bbk cat was 3" in diameter so that I could connect it to the pacesetter header
|
|
|
|
|