08-18-2012, 01:11 AM | #1 |
Drives: 2010 Black 2ss Chevy Camaro Join Date: Nov 2011
Location: Pearl City
Posts: 341
|
Wiring Dual intensity with High wing
Hey guys so i just got my LED bow tie from AAC and was trying to figure out where the 3rd break light and parking light are for me to T-tap the dual intensity circuit to. I got the instructions and it seems that they either forgot to send me a paper or they just expect you to know where these are. The only one i got was the wire diagram and how to take off and put on the bowtie. Nothing about where the wires are or how to get to them.
I was wondering if anyone who installed this before can direct me to where to find these wires. Thanks QUESTION BELOW!!!! So the main thing i was wondering is that i just installed a high-wing spoiler and realized that it has a negative and a power wire. I am assuming the power wire is connected to the 3rd break light due to the fact that it turns on with that break light. Do you guys think that with my dual intensity bowtie could i wire the 3rd break light and the ground to the high-wing spoiler since the wires are right next to each other under the lid? Last edited by Shayne70; 08-18-2012 at 10:19 PM. |
08-18-2012, 10:08 AM | #2 |
Drives: SS camaro Join Date: Apr 2011
Location: Pasadena Texas
Posts: 135
|
There is a white wire under the back seat that controls the center stop light you need to tap into that wire.
Donald |
08-18-2012, 10:24 AM | #3 |
knows 2 facts about ducks
Drives: ...and they're both wrong Join Date: Aug 2009
Location: The HMS Invincible
Posts: 25,072
|
Here you go. You can use a 9V battery to test it, that's what I usually use when testing LED stuffs.
Bowtie Installation Instructions: Remove the Existing Emblem: - Heat the area with a hairdryer until the emblem and decklid are hot to the touch. - Using fishing line start moving with a flossing action from tip to tip. - Remove residue with WD-40, Goo-Gone, or a Rubber Wheel. - Wipe the now clean area with alcohol to remove residue and prepare the surface. 1) Install the LED Emblem: - Route the power wire through the existing deck lid hole and feed excess through.2) Wire the LED Emblem to your Vehicle: - Remove the inner trunk lid liner, there are 10 clips holding it in place.BROWN/WHITE…… = Parking Light BLACK (SOLID)…… = Shared Ground GREEN/WHITE…… = Brake Light |
08-18-2012, 07:18 PM | #4 |
Drives: 2010 Black 2ss Chevy Camaro Join Date: Nov 2011
Location: Pearl City
Posts: 341
|
Donald does the orange or red from the dual intensity go to the white wire and where would the other one attach to
|
08-18-2012, 10:19 PM | #5 |
Drives: 2010 Black 2ss Chevy Camaro Join Date: Nov 2011
Location: Pearl City
Posts: 341
|
New question
|
08-19-2012, 08:53 AM | #6 |
Drives: SS camaro Join Date: Apr 2011
Location: Pasadena Texas
Posts: 135
|
Red wire goes to the white wire under the seat, the orange wire goes to one of the rear tail light feeds.
|
|
|
|
|