07-02-2013, 07:43 AM | #15 | |
2013 Camaro SS1LECTSVZ28
Drives: 2013 AGM 1SS/1LE Join Date: Nov 2012
Location: Suburbs of Detroit, MI
Posts: 2,440
|
Quote:
I didn't know if you were on here or not....Thanks for posting the video...I thought I had my Go-Pro on but I didn't. And I am glad your video matched my description above so I don't look like a liar! For everyone else, I am of course the Grey Camaro 1LE that is lined up in front of Crangie in his red ZL1....he wanted to follow me around a bit to see the lines.....but I had my eyes set on the Boss 302 right out of the gate. Near the end of the video I backed off a hair so we could do a little lead follow and within a lap they waved the checker. Finally, Nice driving! Next time we are out together I want to give you a couple pointers there...(not enough to pass me, just enough to keep up! ) J/K, with a little fine tuning you will be whipping me in that beast. Thanks, Matt
__________________
|
|
07-04-2013, 11:52 AM | #16 |
Drives: 2013 Camaro 1LE 1SS Join Date: Aug 2012
Location: Detroit
Posts: 1,252
|
Matt, how did ur front and rear tires look? My rear left was worn pretty good on the outside but front left was worst. I need rear camber bad, not sure how to fix this without lowering springs. Front I will try to go to -1.6 or so. Maybe I will run 30psi cold too on both axles.
Finally, any luck with the curbs there? Turn one curb would save a lot of time but my car could not take it. As soon as rear tire goes over it the car fishtails.
__________________
I work for General Motors and am not an official spokes person for General Motors. My views and opinions are my own and not those of General Motors.
|
07-04-2013, 01:44 PM | #17 |
Drives: 15 Lexus RCF, 17 Vette Grand Sport Join Date: Apr 2013
Location: South Florida
Posts: 549
|
Cornerspeed. Is that a 4 Point Belt. I was looking at doing a similar set up for the track. With Harness and Tank Bar
|
07-04-2013, 01:52 PM | #18 |
|
No its 6pt.
|
07-05-2013, 12:23 AM | #19 |
Drives: 2010 2SS/RS Join Date: Dec 2009
Location: Clarksville Tennesse.
Posts: 6,062
|
Man the was bad azz would love to come with my 2010SS after mods and run a day with you all an get some pointers. Whats a day cost by the way????
|
07-05-2013, 04:31 AM | #20 | |
Drives: 2013 2SS 1LE NPP GBE Join Date: Sep 2012
Location: Bay Area, online, & in my 1LE
Posts: 2,667
|
Quote:
So, once this is in, can I still use the factory three point harness too? |
|
07-05-2013, 04:32 AM | #21 |
Drives: 2013 2SS 1LE NPP GBE Join Date: Sep 2012
Location: Bay Area, online, & in my 1LE
Posts: 2,667
|
That BMW looked to be very modified. Nice writeup. I agree with your comments about third gear needing a little more oomph.
|
07-05-2013, 09:29 AM | #22 |
Drives: 2021 1LE Join Date: Jul 2011
Location: N'Awlinz
Posts: 6,315
|
|
07-05-2013, 05:08 PM | #23 | |
|
Quote:
Ok so pic #1 is just where the tank plate,and harness bar bolt to the factory belt anchor. pic #2 and#3 are where it bolts to the factory anchor at top and the bottom. I also have the tank plate installed here as well, you can just barely see it. pic #4 and #5 are just the same thing,only the drivers side. pic #6 is a good pic of the tank plate,and how it bolts right under the seat rails,you can also see how the tank plate,harness bar,and the original 3pt belt bolts right in,and as you can see there is no interference what so ever. pic #7 is just a good close up of the connection point. |
|
07-05-2013, 08:48 PM | #24 |
Drives: 2013 2SS 1LE NPP GBE Join Date: Sep 2012
Location: Bay Area, online, & in my 1LE
Posts: 2,667
|
2nd Track Day in my 1LE: Gingerman
Mark:
It's a Schroth harness. Should I get the pads too? http://www.hmsmotorsport.com/store/s...allye/rallye-3 Thanks for your write up. Going to read it now. Brian PS - I think we went off topic. Maybe we ought to move this to a new thread. :-O
__________________
|
07-06-2013, 01:44 PM | #25 | |
|
Quote:
Let me know if you have any questions.Mark
__________________
|
|
07-06-2013, 04:07 PM | #26 |
|
I also plan on getting the Schroth ASM belts for my car. I plan on testing out the car with recaros only first before i upgrade. Are you sure the ralleye 3 fits, i thought we needed the ralleye 4 setup. I will look into this.
Dropspeed, what are you using for track lap recorder? I have trackmaster on my phone but i have not used it yet.
__________________
Used Racing Brake 2 Peice Rotors for sale:
http://www.camaro5.com/forums/showthread.php?t=344754 Summit White 2014 2SS 1LE Recaros, NPP exhaust, Nav 2010 2SS A6 - sold. |
07-06-2013, 06:38 PM | #27 |
Drives: 2013 2SS 1LE NPP GBE Join Date: Sep 2012
Location: Bay Area, online, & in my 1LE
Posts: 2,667
|
HM Motorsports said only the 3 would work. But now Cornerspeed has spooked me so I need to see if the harness works without the tank plates.
__________________
|
07-06-2013, 06:40 PM | #28 |
Drives: 2013 2SS 1LE NPP GBE Join Date: Sep 2012
Location: Bay Area, online, & in my 1LE
Posts: 2,667
|
From HM "It’s designed to use the stock mounting locations for the lap belts, and the shoulder belt will mount to the C-pillar, where the factory 3 point is attached."
__________________
|
|
|
Thread Tools | |
|
|