04-18-2016, 06:14 PM | #1 |
Drives: 2012 ZL1 #1329 M6 Join Date: Jun 2009
Location: Reading, PA
Posts: 1,040
|
First Time To the Track in 7 Years
1st Pass- 11.8 @ 126mph
2nd Pass- 11.4 @ 128mph 3rd Pass- Smoked them- 12.5 @ 128mph I had to hash out a problem with my Hurst Roll Control. I think I got it situated now. 60ft's were terrible. Had a great time though. My goal is to get this pig into the 10s.
__________________
2012 Camaro ZL1 #1329 M6 Summit White
Built by Mike @ Rapid Motorsports 784rwhp 757 rwtq on 93 Octane ET - 10.97 @ 128 Heads-Blower-Snout-TB ported & prepared by Jeremy Formato of FasterProms http://www.camaro5.com/forums/showthread.php?t=395950 Rapid Motorsports 396ci Build https://www.camaro5.com/forums/showt...1#post10321301 10.832 @ 130.99 |
04-18-2016, 07:35 PM | #2 |
Drives: 2013 ZL1 A6 #4801 Join Date: Mar 2016
Location: Pensacola, Florida
Posts: 241
|
MPH shows a lot more potential. If you can get it to hook up, you may very well be in the 10's.
|
04-18-2016, 09:42 PM | #3 |
Banned
Drives: Camaro Join Date: Mar 2013
Location: USA
Posts: 2,701
|
What was your best 60'?
|
04-19-2016, 04:09 AM | #4 |
Drives: 2012 ZL1 #1329 M6 Join Date: Jun 2009
Location: Reading, PA
Posts: 1,040
|
I will get my time slips out of the car when I get home and take a look. I forget. All I know is they are garbage.
__________________
2012 Camaro ZL1 #1329 M6 Summit White
Built by Mike @ Rapid Motorsports 784rwhp 757 rwtq on 93 Octane ET - 10.97 @ 128 Heads-Blower-Snout-TB ported & prepared by Jeremy Formato of FasterProms http://www.camaro5.com/forums/showthread.php?t=395950 Rapid Motorsports 396ci Build https://www.camaro5.com/forums/showt...1#post10321301 10.832 @ 130.99 |
04-19-2016, 04:11 AM | #5 |
Drives: 2012 ZL1 #1329 M6 Join Date: Jun 2009
Location: Reading, PA
Posts: 1,040
|
Definitely. Driver (me) just needs more seat time. One thing with Maple Grove Raceway is, to much idle time between passes. like an hour and 20 minutes. All the other drag strips near me are an 1-2 hours away.
__________________
2012 Camaro ZL1 #1329 M6 Summit White
Built by Mike @ Rapid Motorsports 784rwhp 757 rwtq on 93 Octane ET - 10.97 @ 128 Heads-Blower-Snout-TB ported & prepared by Jeremy Formato of FasterProms http://www.camaro5.com/forums/showthread.php?t=395950 Rapid Motorsports 396ci Build https://www.camaro5.com/forums/showt...1#post10321301 10.832 @ 130.99 |
04-19-2016, 10:41 AM | #6 |
Drives: 67RS Camaro ,Black 2013 ZL1 Join Date: Jun 2010
Location: Alberta
Posts: 1,408
|
Good to see you got to the track for some fun.
Now it's time to get that 4800lb beast on a diet. |
04-19-2016, 05:03 PM | #7 |
Drives: 2012 ZL1 #1329 M6 Join Date: Jun 2009
Location: Reading, PA
Posts: 1,040
|
I was waiting for your response man! Lance has been helping me out with some information regarding the bottom end he was running in his M6 ZL1. He brought you up! Yeah, I had a good time, just want to get this machine in the 10s. I am going to try and get down to the track again Sunday. I wish Maple Grove had more Test & Tunes. They have an event called the "High School Challenge" this weekend, but due to poor turnout the past couple of years, they are opening it up to alumni from what I heard. Now I been out of school 10 years so I don't know. I will call the track this week sometime.
__________________
2012 Camaro ZL1 #1329 M6 Summit White
Built by Mike @ Rapid Motorsports 784rwhp 757 rwtq on 93 Octane ET - 10.97 @ 128 Heads-Blower-Snout-TB ported & prepared by Jeremy Formato of FasterProms http://www.camaro5.com/forums/showthread.php?t=395950 Rapid Motorsports 396ci Build https://www.camaro5.com/forums/showt...1#post10321301 10.832 @ 130.99 |
04-20-2016, 12:13 AM | #8 |
Drives: 2014 M6 ZL1 Join Date: Jan 2012
Location: Tarpon Springs, Fl
Posts: 772
|
Way to get that Monster finally to the track Man. MPH shows promise. What was th DA? Also, do you know what rpm you are you launching and shifting at? There definitely is more MPH in that beast.
Also, try to record your tire pressure and start dropping 1-2 lbs of air in the rear tires on each pass if you keep spinning. Don't go below 15 lbs on the 20" MT DRs. Great job getting out there and getting some baseline runs. It gets more fun each time!!
__________________
15' Ashen Gray Metallic Z/28
14' Crystal Red Tintcoat ZL1 6M, 9.62 at 150.75 MPH 12' Opulent Blue Metallic CTS-V Sedan, 10.690 at 129.60 MPH - SOLD 06' LeMans Blue Metallic Z06, 11.726 at 127.80 MPH Motor - SOLD. 96' Impala SS LTx, 11.397 at 118.10 MPH Motor, 1st stage 10.526 at 127.46 MPH |
04-20-2016, 04:50 AM | #9 | |
Drives: 2012 ZL1 #1329 M6 Join Date: Jun 2009
Location: Reading, PA
Posts: 1,040
|
Quote:
__________________
2012 Camaro ZL1 #1329 M6 Summit White
Built by Mike @ Rapid Motorsports 784rwhp 757 rwtq on 93 Octane ET - 10.97 @ 128 Heads-Blower-Snout-TB ported & prepared by Jeremy Formato of FasterProms http://www.camaro5.com/forums/showthread.php?t=395950 Rapid Motorsports 396ci Build https://www.camaro5.com/forums/showt...1#post10321301 10.832 @ 130.99 |
|
04-20-2016, 10:17 PM | #10 |
Drives: 2014 M6 ZL1 Join Date: Jan 2012
Location: Tarpon Springs, Fl
Posts: 772
|
You doing great Man!! Especially with that combo banging gears for the 1st time at the track in 7 years. That 11.4 pass at 128 mph says it all.
You will be deep in the 10's with a few more track days in good air and track prep. PM me if you need anything. Nice job!!
__________________
15' Ashen Gray Metallic Z/28
14' Crystal Red Tintcoat ZL1 6M, 9.62 at 150.75 MPH 12' Opulent Blue Metallic CTS-V Sedan, 10.690 at 129.60 MPH - SOLD 06' LeMans Blue Metallic Z06, 11.726 at 127.80 MPH Motor - SOLD. 96' Impala SS LTx, 11.397 at 118.10 MPH Motor, 1st stage 10.526 at 127.46 MPH |
04-21-2016, 07:15 AM | #11 | |
Drives: 2012 ZL1 #1329 M6 Join Date: Jun 2009
Location: Reading, PA
Posts: 1,040
|
Quote:
__________________
2012 Camaro ZL1 #1329 M6 Summit White
Built by Mike @ Rapid Motorsports 784rwhp 757 rwtq on 93 Octane ET - 10.97 @ 128 Heads-Blower-Snout-TB ported & prepared by Jeremy Formato of FasterProms http://www.camaro5.com/forums/showthread.php?t=395950 Rapid Motorsports 396ci Build https://www.camaro5.com/forums/showt...1#post10321301 10.832 @ 130.99 |
|
04-21-2016, 07:20 AM | #12 |
Drives: 1968 Camaro, 2012 ZL1 Join Date: Nov 2011
Location: Aston, PA
Posts: 398
|
Too bad you are not closer to Cecil County, MD. I have been basically able to hot lap there on Wednesdays.
|
04-21-2016, 08:01 PM | #13 |
Drives: 2012 ZL1 #1329 M6 Join Date: Jun 2009
Location: Reading, PA
Posts: 1,040
|
Jeez, That must be nice! Yeah, that is a little out of my way.
__________________
2012 Camaro ZL1 #1329 M6 Summit White
Built by Mike @ Rapid Motorsports 784rwhp 757 rwtq on 93 Octane ET - 10.97 @ 128 Heads-Blower-Snout-TB ported & prepared by Jeremy Formato of FasterProms http://www.camaro5.com/forums/showthread.php?t=395950 Rapid Motorsports 396ci Build https://www.camaro5.com/forums/showt...1#post10321301 10.832 @ 130.99 |
04-24-2016, 06:51 PM | #14 |
Drives: 2012 ZL1 #1329 M6 Join Date: Jun 2009
Location: Reading, PA
Posts: 1,040
|
Ran today. Managed a 11.2 at 128mph. I did manage a 129 mph pass, but terrible ET. I am going to keep pushing!
__________________
2012 Camaro ZL1 #1329 M6 Summit White
Built by Mike @ Rapid Motorsports 784rwhp 757 rwtq on 93 Octane ET - 10.97 @ 128 Heads-Blower-Snout-TB ported & prepared by Jeremy Formato of FasterProms http://www.camaro5.com/forums/showthread.php?t=395950 Rapid Motorsports 396ci Build https://www.camaro5.com/forums/showt...1#post10321301 10.832 @ 130.99 |
|
|
|
|