SF Bay Area Performance shop that can install 3.91 gears and recalibrate

[elektrik]

Hey Guys. Any local members know of a performance shop in the East bay that can install 3.91 gears if I purchase them (and recalibrate) *other* than a dealer? I ask cause the dealer quoted me $2000 to have them installed and the gear kits themselves can be purchased for like $400.

[CamaroCracka]

I would drive to Vegas. The SF area did not seem rod friendly to me. Maybe Oakland, but I was too scared to go there.

[Rigzo510]

I would look into Borelli Motorsports

[OHIOSS]

Good luck getting your speedo recalibrated. I had 3.91 gears installed at a dealer and they told me no problem recalibrating the speedo but in the end they couldn't do it. They claim that GM doesn't have the software to do the calibration. I called every dealer within 50 miles and several of them told me it would be no problem but I asked them to check before I dropped the car off. One by one they all called me back and said they couldn't do it. I went 2 years with the speedo showing 10MPH faster and mileage stacking up that I didn't actually drive.

I got lucky when I contacted the company that did my engine tune. They said they think they could do it by hooking up their laptop to the cars computer. I wasn't very confident that they would be able to do it but thankfully they did recalibrate the speedo to the 3.91 gears.

You better check with the dealer to be sure they can recalibrate to the 3.91 gear ratio. The dealer that did my gear change was SURE they could do the recalibration but they were wrong.

Good luck.

Russ

[Nor Cal ZL1]

Abel Chevrolet Rio Vista. They do alot of performance Vette and Camaro work.

Only place I take my Z.


http://www.yelp.com/biz/abel-chevrol...k-co-rio-vista

[King Sun]

Originally Posted by CamaroCracka

I would drive to Vegas. The SF area did not seem rod friendly to me. Maybe Oakland, but I was too scared to go there.

[macwest]

Originally Posted by Nor Cal ZL1

Abel Chevrolet Rio Vista. They do alot of performance Vette and Camaro work.

Only place I take my Z.


http://www.yelp.com/biz/abel-chevrol...k-co-rio-vista

Either able in rio vista or synergy in livermore. I take my car to both and have had excellent service.

[69camaroSS]

Look up Blu808...great shop! Luke will hook you up!

[Sandor]

Originally Posted by OHIOSS

Good luck getting your speedo recalibrated. I had 3.91 gears installed at a dealer and they told me no problem recalibrating the speedo but in the end they couldn't do it. They claim that GM doesn't have the software to do the calibration. I called every dealer within 50 miles and several of them told me it would be no problem but I asked them to check before I dropped the car off. One by one they all called me back and said they couldn't do it. I went 2 years with the speedo showing 10MPH faster and mileage stacking up that I didn't actually drive.

I got lucky when I contacted the company that did my engine tune. They said they think they could do it by hooking up their laptop to the cars computer. I wasn't very confident that they would be able to do it but thankfully they did recalibrate the speedo to the 3.91 gears.

You better check with the dealer to be sure they can recalibrate to the 3.91 gear ratio. The dealer that did my gear change was SURE they could do the recalibration but they were wrong.

Good luck.

Russ

Russ, again sorry to hear the troubles you had. Chevrolet dealers do in fact have access to the cal and are authorized to run it. It is a component of the kit and required to maintain the vehicle warranty. What happened in your case is you had the gear installed before it was released as a performance kit. There was no cal until it was officially released as a kit.

[Sandor]

Originally Posted by elektrik

Hey Guys. Any local members know of a performance shop in the East bay that can install 3.91 gears if I purchase them (and recalibrate) *other* than a dealer? I ask cause the dealer quoted me $2000 to have them installed and the gear kits themselves can be purchased for like $400.

You may want to shop around. I had them installed for about $950 parts and labor. And having it done at the dealership preserves your warranty.

[Tenring]

I have been getting quotes form $1300 to $1400 at some local Chevy Performance shops around here. If I could get it done for $950 I would drop it off tomorrow

[CamaroCracka]

On a serious note, I bought the gears with just the pinion nut, ring bolts and crush sleeve for $250 and went to put them in myself. When I could not get the yoke to seat with a 3/4 drive ratchet and a cheater pipe I call the machine shop and he sent me to an old timer who did remaining work for $250.

If you take the diff out and take it to a shop with the gears, they can probably install whatever kit you buy for $300-350. At 2011, your almost out of warranty so do you really need a dealership to put gears in. Hell, for an extra 2k more than what they are asking you can have the ZL1 kit which has way more strength than the AAM 218mm ever will and it comes with HD axles too.

[elektrik]

Originally Posted by Nor Cal ZL1

Abel Chevrolet Rio Vista. They do alot of performance Vette and Camaro work.

Only place I take my Z.


http://www.yelp.com/biz/abel-chevrol...k-co-rio-vista

ha! i should've known! that's where I bought her! i'm afraid to find out how much it would cost...but i'll ask em

[elektrik]

Originally Posted by Comrando

Chevy part numbers:


http://www.chevrolet.com/content/dam...o-19301504.pdf

I suppose the next (possibly rhetorical) question would be: would any dealer do this if they weren't the ones to install the kit?