09-09-2013, 12:34 PM | #1 |
Drives: 2013 ZL1, 1971 Camaro Join Date: Nov 2012
Location: Colorado
Posts: 60
|
Tuning done--Question
My car put down 701hp and 650 torque on a Mustang dyno. The torque is over 600 before 3000 and is steady near 650 all the way to 6600 is this normal? I've seen cars with a lot more torque on here. 14psi boost.
Daren |
09-09-2013, 07:43 PM | #2 |
Drives: Camaro ZL1 Join Date: May 2012
Location: Houston
Posts: 233
|
650 is pretty solid with those mods assuming you are running pump gas.
__________________
2012 A6 Coupe 630RWHP 10.93@125
Mods: ID850 Injectors; D3PE HX, Reservoir & Atmospheric Catch-Can; LPE 2.55 Upper & 9.1 Lower Pulleys w/ ATI Damper; LPE Idler Pulley Relocation Bracket; "Green" Serp. Belt; Cat delete;ADM Exhaust Override; Magnaflow X-Pipe Muffler (in addition to stock mufflers); Cold Air Inductions CAI; 160 thermostat; LS9 Isolator; Port/polish snout and intake runners; LPE GT9 camshaft with dual springs and titanium retainers; Kenne Bell BAP, Install and Engine Tune by Serious Hp; Fab work by D3 Performance Engineering; Trans Tune by Keith; Coming Soon: Flex Fuel Conversion. |
|
|
|
|