Cut out fix?

[Cali_Camaro_SS]

So I have a brand new pair of DMH cutouts and both did not work when I received even when applying power to it they would not open

Any way of fixing this since the company I think is gone
can you take it apart and fix it my self or anyone know how to?

[2SSCAMARO]

I think you need to look again at how you have wired the units. One bad new unit....maybe, both units bad makes me think it's a wiring issue or even a bad switch control. The probability of receiving two defective new motors is not very likely.

[Cali_Camaro_SS]

Well no because I already had cutouts installed and I sent in the old ones that broke over time so they sent me these, try them out and dont work

they send me a second set and boom they work

so not the wiring

But thank you for the input

[2SSCAMARO]

Originally Posted by Cali_Camaro_SS

So I have a brand new pair of DMH cutouts and both did not work when I received even when applying power to it they would not open

Any way of fixing this since the company I think is gone
can you take it apart and fix it my self or anyone know how to?

Originally Posted by Cali_Camaro_SS

Well no because I already had cutouts installed and I sent in the old ones that broke over time so they sent me these, try them out and dont work

they send me a second set and boom they work

so not the wiring

But thank you for the input

Just curious....How do you go from "the company I think is gone" to "they send me a second set and boom they work" in 24 hours?

[Cali_Camaro_SS]

LOL sorry i should really explain things more clear

They sent me those others ones that work a while back not just now lol

I think they are out of business right now though, it took me like 2 months to reach them for that pair and I think some one on here drove by the place and his house and no one was there, they dont pick up the phone ever for anyone.

But yea didnt mean to confuse

[StephenS_84]

Yes, the company is gone.

[2SSCAMARO]

So If I understand you correctly, you have a working set on your car and a spare set that does not operate. I would try applying 12 volts DC directly to the motor power leads to check out the motors. If the motors are shot, you might be able to find replacement motors. If not, the remaining parts of the units would be good for spare parts.

[Cali_Camaro_SS]

Yes I have applied direct power to it and a no go

well usually the spare parts id need are the motors lol so dont know hope i can just fix them some how