07-22-2013, 09:54 AM | #1 |
vinyl emblem cover installation
Hi all. I just ordered a vinyl rear blackout panel and front and rear emblem blackouts and there are absolutely no instructions whatsoever as to how to install them. I'm assuming its just a peel and stick thing, but I really have no idea. Any suggestions? Thanks.
|
|
07-22-2013, 10:00 AM | #2 |
Drives: 2012 Corvette Grand Sport Join Date: Jan 2011
Location: martinez Ga.
Posts: 503
|
You can use a spray bottle with water and a little soap,two or three drops, spray the emblem and peel the sticker and spray the sticky side align the sticker squeegy out the bubbles and leave to dry at least 24 hrs. Or if you are good just peel and lay in a corner then squeegy it down.
__________________
Casper is a 2012 Corvette Grand Sport w/ Heritage package.
|
07-22-2013, 10:05 AM | #3 |
Drives: 2010 Silver 1LT/RS Join Date: Apr 2012
Location: St. Louis
Posts: 163
|
Spray with mix of dish soap and water like ^. I did emblem and the back part that is sticky. Then take a squeegy (i used one that was for a screen shield for a cell phone) to remove bubbles. Then set out in sun for a few hours.
|
07-22-2013, 10:56 AM | #4 |
Turns out the thing was a flimsy piece of junk. I tore the thing almost immediately. Ended up throwing it away. Wasted 30 bucks. Thanks for the advice though.
|
|
07-22-2013, 11:09 AM | #5 |
Drives: camaro 2LS LFX A6 Join Date: Jun 2013
Location: South Florida
Posts: 614
|
Plastidip it ! Easy
__________________
Niche 20x10.5, BMR 1.25 springs, GFX splitter,1LE Diffuser w/ 3.5 quad tips
|
07-24-2013, 03:54 PM | #6 |
Ah DJ-IOM ZL1 haha
Drives: 13 IOM ZL1 M6 & 10 SIM 2SS M6 Join Date: Jul 2009
Location: Hope Mills, NC
Posts: 580
|
I am with rozay... Plastidip!
__________________
2013 IOM ZL1 #002415 Born 09/13/12
2010 SIM 2SS/RS #005549 Born 05/02/09 |
|
|
|
|