03-22-2012, 07:40 PM | #1 |
Drives: 2011 Yellow 2LT RS Camaro Join Date: Apr 2011
Location: Kalamazoo mi
Posts: 84
|
No Audio Output on Amp
I just installed the FARK from ******** and I was trying to setup the input sensitivity. By measuring it using a 1000 hz tone and measuring he volts coming out of the output for the speakers. I tried using just the left by connecting my positive side of meter to and I got no reading. I then connected the negative to the same channel and still got no reading. I then disconnected the amp and measured the output of the RCA outs from the fark and got .02v. What would cause me to get no reading when I'm measuring the speakers out? I am using a xd700/5
|
03-22-2012, 09:27 PM | #2 |
Drives: 2010 1SS/RS SIM L99 Join Date: Jul 2009
Location: Houston, TX
Posts: 153
|
Are you using the AC Voltage setting on your Multimeter? Make sure it is NOT set to read DC Voltage.
|
03-24-2012, 11:43 AM | #3 |
Drives: 2011 Yellow 2LT RS Camaro Join Date: Apr 2011
Location: Kalamazoo mi
Posts: 84
|
Thanks for the tip, it got me going. Turns out the voltmeter was jacked up. Bought a new one and everything is great.
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Batmobile | Fraxum | Member Car Journals | 51 | 03-16-2014 01:38 AM |
Amp Power Management Template | BlackRS2011 | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 3 | 12-29-2011 01:46 PM |
Car audio experts | Matic | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 2 | 08-07-2011 09:53 PM |
Another ******** install - Phase 2 | Fraxum | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 7 | 07-11-2011 09:39 PM |
Press release: 2010 Camaro Audio by Visteon and Boston Acoustics | Mike C | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 49 | 07-07-2009 02:11 PM |