04-06-2010, 07:46 PM | #1 |
Drives: 2lt Red jewel vin#6632 Join Date: Apr 2009
Location: Grand Rapids, MI
Posts: 84
|
jl stealthbox install
Finally got the jl stealthbox install done with 500/1 amp. Sounds great but need to figure out how to stop my rearview mirror from shaking so bad, cant even use it.
|
04-06-2010, 07:52 PM | #2 |
Drives: Black 2ss 6m with cyber grey strips Join Date: Mar 2010
Location: Sanford, NC
Posts: 76
|
really nice
|
04-06-2010, 08:01 PM | #3 |
Drives: 2010 2SS IOM L99 Join Date: Jan 2010
Location: LOUISVILLE,KY..
Posts: 7,545
|
turn the radio down.
|
04-06-2010, 08:09 PM | #4 |
Drives: 2lt Red jewel vin#6632 Join Date: Apr 2009
Location: Grand Rapids, MI
Posts: 84
|
shakes crazy at 18
|
04-07-2010, 08:34 AM | #5 |
400HP used to be enough..
Drives: 2010 2SS rs manual Join Date: Aug 2009
Location: Central NC
Posts: 772
|
You should add the remote bass control like I am doing. It's a single knob control you can mount up front and allows you to adjust the boost of the subwoofer. It plugs into the JL amp (there is a phone plug jack for it). Also, check the settings on the amp. Infrasonic filter should be on, freq at 30. Bass EQ to ON. "Q" at 1.6, center freq to 60. Amp LP filter to 12db. Filter freq to 80.
Hope this helps.
__________________
Build thread: http://www.camaro5.com/forums/showthread.php?t=47925
|
04-07-2010, 08:38 AM | #6 |
did you use a line input off of one of the back speakers as your source?
|
|
04-07-2010, 05:28 PM | #7 |
Drives: 2lt Red jewel vin#6632 Join Date: Apr 2009
Location: Grand Rapids, MI
Posts: 84
|
had it installed dont know what they did
|
04-07-2010, 05:30 PM | #8 | |
Drives: 2lt Red jewel vin#6632 Join Date: Apr 2009
Location: Grand Rapids, MI
Posts: 84
|
Quote:
|
|
04-09-2010, 04:42 AM | #9 |
Drives: 2SS Camaro Join Date: Oct 2009
Location: CA
Posts: 439
|
Really nice setup. If you dont mind me asking, how much did the stealth, amp and install run you? They did a nice job with the amp. I want to get that done for my car too.
Thx! |
04-10-2010, 07:11 PM | #10 |
Drives: 2lt Red jewel vin#6632 Join Date: Apr 2009
Location: Grand Rapids, MI
Posts: 84
|
|
05-26-2010, 03:06 PM | #11 |
Anthony Cascio
|
Comments on your J.L. Audio Subwoofer Amp Install
I also recently purchased the J.L. Audio Stealthbox with single 12” subwoofer & the 500/1v2 monoblock subwoofer amplifier for my Summit White Camaro 2SS/RS. I’m doing my own install and appreciate your installation photos. I have the system hooked up & running. My amp is currently sitting on the floor of the trunk & I like the location of your amp inside the trunk, under the the rear window panel speaker deck. Your photos indicate the your amp is mounted horizontally, upside down. The amp installation manual rates that as “Fair” for cooling efficiency. Installing the amp horizontally, right side up, is rated “Good” for cooling efficiency. You may want to question the installer as to his/her reason for installing the amp in a less desirable position for heat dissipation. Perhaps he/she liked being able to view the three indicator lights on the top of the amp by having them face down towards the floor of the trunk, rather than up where they would be difficult or impossible to see, since they would be very close the rear window speaker panel. Excessive heat build-up can lead to degraded performance of the amp, according to J.L. Audio. My preference will be to install the amp in the same location as yours but with the amp right side up & with the controls/switches/wiring side of the amp facing towards the back of the vehicle so I have direct access to that side of the amp and can view it from the rear of the vehicle. Your installer opted to install the controls/switches/wiring side of the amp facing forward, possibly to better hide the wiring from view & to shorten the wiring runs.
Last edited by TonyCigar; 06-24-2010 at 02:05 PM. |
05-26-2010, 03:09 PM | #12 |
|
looks awesome
__________________
Jannetty Racing JRE Street Package
|
08-24-2010, 10:09 PM | #13 |
|
Holy crap! $1800!?!?
__________________
MBRP Catback/Magnaflow Resonated X/Airraid V2 CAI/Dash ABL/Interior LEDs/Custom Paint/Jet Coated American Racing LT Headers/High Flow cats/Trifecta Tune |
08-25-2010, 01:08 PM | #14 |
Drives: 2011 Camaro SS/RS LS3 Join Date: Aug 2010
Location: Texas
Posts: 1,630
|
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY : Install headers on 2010 Camaro SS | Nine Ball | Camaro DIY & HOW-TO instructions & discussions | 70 | 06-25-2020 06:40 PM |
DIY : Install Performance Swaybars in 2010 Camaro | Nine Ball | Camaro DIY & HOW-TO instructions & discussions | 17 | 09-14-2015 12:36 AM |
Complete ******** install from a Novice | Susantroy1 | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 63 | 07-31-2015 01:25 PM |
DIY Hurst Short Throw Shifter Install - Pix and Video | TAG UR IT | Camaro DIY & HOW-TO instructions & discussions | 121 | 02-26-2015 10:08 AM |