05-03-2011, 06:28 PM | #1 |
Yut
Drives: CGM 2010 2SS/RS M6 Join Date: Apr 2011
Location: New Bern, NC
Posts: 6
|
Side panel coming off?
Has anyone had any problems with the side panels bordering the windshield on the interior popping out of the clip that holds them in? My panels on both sides are coming off and they won't snap back in anymore.
|
05-03-2011, 06:33 PM | #2 |
knows 2 facts about ducks
Drives: ...and they're both wrong Join Date: Aug 2009
Location: The HMS Invincible
Posts: 25,072
|
The clips are probably broken. Just take it in under warranty.
|
05-04-2011, 02:09 AM | #3 |
Drives: 17 SS Sedan, 04 SSR Join Date: May 2009
Location: Sacramento
Posts: 333
|
There's a TSB for this issue. The clips that hold the A-pillar trim pieces in place near the roof (at least for the early 2010 Camaros) were insufficient to hold the trim panel in place. My a-pillar trim pieces would pop away when the interior would heat up (especially in the summer time).
The TSB has the dealership replace the original clips with a redesigned clip (P/N 11611318). I recently installed these updated clips on my 05/2009 produced 2010 Camaro. The clips only cost $2.20 (that's what I paid for them) so the $5 for clips is a lot cheaper than me driving over to the service department 25 miles away plus the possibility of them damaging the car while it's being worked on. So far, the a-pillar trim pieces are staying in place with the new clips.
__________________
|
05-05-2011, 03:28 PM | #4 |
Drives: GM Vehicles Join Date: Jun 2010
Location: Michigan
Posts: 9,328
|
southpaw_af, have you been to get this issue taken care of either on your own or through your dealer yet? Thank you for your time.
Jeff Morris, Chevrolet Customer Service |
05-06-2011, 10:29 PM | #5 |
Yut
Drives: CGM 2010 2SS/RS M6 Join Date: Apr 2011
Location: New Bern, NC
Posts: 6
|
Nope, I haven't had time yet. I'm going to try and get it taken care of tomorrow. Thanks for the input guys.
edit: I went over today but the service center is closed on Saturdays. Any idea of where I can purchase the clips so I can do it myself? I really have zero free time during the week until about October.\ edit2: I finally fixed it. Thanks for the tip shiftz33, I ordered 2 of P/N 11611318 from gmpartsdirect.com for like $3 each, but they got me on shipping...12 bucks. It was worth not having to drive all the way out to an open dealer on a Saturday; took 5 minutes to install them. Last edited by southpaw_af; 05-21-2011 at 04:13 PM. |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GM bulletin on Perceived Paint Mismatch on Door and Quarter Panel Paint Appearance | Tran | 5th Gen Camaro SS LS LT General Discussions | 114 | 04-16-2012 03:04 PM |
New rattle noise at 45 Mph and above... | Edrock | Camaro Issues / Problems | Warranty Discussions | TSB and Recalls | 51 | 01-29-2012 12:51 PM |
WTB Passenger side rocker panel V6 | masterofpuppets | Exterior Parts & Accessories | 3 | 02-23-2011 03:18 PM |
Side Mount Amp Rack Pics | Steve@Subthump | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 0 | 09-12-2009 02:27 PM |