04-15-2014, 05:02 PM | #1 |
Drives: 2010 IOM Camaro Join Date: Aug 2012
Location: DFW
Posts: 3,112
|
Any ZL1 front ends with Dual Scanner installed??
Looking to see photos or videos of ZL1 front ends with dual Scanner Leds. I have seen one in the upper grill Grill area but looking to see if anyone installed in lower area of the grill.
|
04-15-2014, 05:05 PM | #2 |
COTW 12/3/12
Drives: 2012 Ashen Gray ZL1 Join Date: Aug 2011
Location: Glen Carbon, IL
Posts: 3,279
|
I have mine installed in the upper grill flanking the sides of the bowtie, so it may be my video you saw. I haven't seen any others at all besides mine.
|
04-15-2014, 05:07 PM | #3 |
Drives: 2010 IOM Camaro Join Date: Aug 2012
Location: DFW
Posts: 3,112
|
Only issue is having a Heritage Grill. The other issue is not really wanting to see Obvious LED's sticking out when off at show during the day. Do you have photos of yours off. Think I have seen video of them on
|
04-15-2014, 07:08 PM | #4 |
COTW 12/3/12
Drives: 2012 Ashen Gray ZL1 Join Date: Aug 2011
Location: Glen Carbon, IL
Posts: 3,279
|
I was worried about the same thing, so I recessed mine behind the grill about an inch and wrapped each side in matte tinted vinyl film. During the day you don't see them at all unless I point them out and even then you pretty much need to be eye level with the grill to see them. Here's a couple crappy cell phone pics I just took from a low angle. Sorry for the glare, the sun is in a bad spot right now.
|
04-15-2014, 09:38 PM | #5 |
Drives: 2010 IOM Camaro Join Date: Aug 2012
Location: DFW
Posts: 3,112
|
I thought yours were more by the groove on either side of the bow tie. I like your setup a lot. Any video?
Sent from my iPhone using Tapatalk |
04-15-2014, 10:09 PM | #6 | ||
COTW 12/3/12
Drives: 2012 Ashen Gray ZL1 Join Date: Aug 2011
Location: Glen Carbon, IL
Posts: 3,279
|
Mine are in the slot just above the ZL1 emblem on either side of the top of the bowtie.
Video at night: My mockup testing prior to installing on the car: |
||
04-21-2014, 10:19 AM | #7 |
Drives: 2010 IOM Camaro Join Date: Aug 2012
Location: DFW
Posts: 3,112
|
Hey Deke quick question. When installing your scanner. You did behind the grill correct? In person did you have any issues with the light being block by any slats in the grill? In the video doesnt appear so. It looks like scanner mounted behind a couple of the grill slats.
Also what did you use to secure |
04-21-2014, 11:05 AM | #8 |
Drives: 2013 2LT RS Blue Ray Metallic Join Date: Feb 2014
Location: USA
Posts: 128
|
Looking to do this too. Getting the zl1 grille and then will buy the LEDs. Interested to hear how you did it, and which led bar you bought. |
|
|
|
|