02-26-2014, 10:27 PM | #1 |
Drives: 2010 aqua blue SS/RS M6 Join Date: Feb 2010
Location: plainfield, IL
Posts: 2,706
|
Fastest cam only?
Wondering if 11.37 is the fastest cam only pass? On the fast list everyone faster has head work done. If not 11.37 what is it, thanks.
__________________
10.91 at 122 H/C stock block N/A
|
02-26-2014, 11:15 PM | #2 |
Drives: Pontiac G8 GT Join Date: Jan 2011
Location: Toledo
Posts: 115
|
I would think a bunch faster than that... heck a g8 going NA did 10.5......
__________________
Sleeper Pontiac G8 Gt; LSX 430 with Procharger F1x ; 25psi; 4L80E conversion; Hendrix 9" rear/driveshaf; Camaro brembos; (1209rwhp
|
02-26-2014, 11:24 PM | #3 |
CamaroFans.com
|
That's a damn good number cam only... Definitely top of the list.
|
02-27-2014, 08:41 AM | #4 |
chevy pride
|
didnt rhino go 10 cam only?
__________________
check out ky speeds fb page https://www.facebook.com/kyspeed |
02-27-2014, 09:21 AM | #5 |
Drives: 2011camaro SS Join Date: Nov 2012
Location: Allen, Tx
Posts: 2,201
|
Rhino went 10.7 cam only.
I've went 11.4 with stock cam and bolt Ons. |
02-27-2014, 09:21 AM | #6 |
|
I went 10.75 @126.22. That is a good time though.
|
02-27-2014, 09:22 AM | #7 |
Drives: 2011camaro SS Join Date: Nov 2012
Location: Allen, Tx
Posts: 2,201
|
|
02-27-2014, 10:30 AM | #8 |
Drives: 2013 SS Join Date: May 2013
Location: DFW
Posts: 4,102
|
Yeah buddy!
__________________
|
02-27-2014, 11:32 AM | #9 |
Drives: 2013 ZL1 Join Date: Jan 2010
Location: Katy, TX
Posts: 199
|
Ive gone 11.31 cam only. looking to go quicker come time for C5fest. I ran that a year and half ago. I havent posted it because I lost my timeslip.
|
02-27-2014, 03:29 PM | #10 |
Drives: 2010 aqua blue SS/RS M6 Join Date: Feb 2010
Location: plainfield, IL
Posts: 2,706
|
Ok 10.75, I figured someone beat that 11.37! That's the last cam only pass in the fast list. Dought I will get close to that, so we have 11.31 and 10.75, anyone know of anyone else?
Picked up my race star 17x4.5s ( have 275s on front) Trans will be setup to hold 1st gear ( was short shifting) This will be next time out. Then I still plan on... Under drive pulley Rhino modded intake Ported TB VR tune model Swap 18" vett rears for matching race stars I think 11.2s are could be in reach. Wondering were I will stack up with other cam only cars. I know I am running the smallest cam that's for sure.
__________________
10.91 at 122 H/C stock block N/A
|
02-27-2014, 03:39 PM | #11 |
Drives: 2013 ZL1 Join Date: Jan 2010
Location: Katy, TX
Posts: 199
|
Im looking to have 3.91 in by next time I go out to the track. Already been retuned and car pulls a lot harder than before. My 11.31 pass I was at 491 on dyno. Now I am at 509 hp 473 tq. So new tune, 3.91's, and weight reduction..Im looking to run 10's. Been my goal since I got my car.
|
02-27-2014, 05:23 PM | #12 |
Drives: 2010 aqua blue SS/RS M6 Join Date: Feb 2010
Location: plainfield, IL
Posts: 2,706
|
That is also my end goal, but right now I don't have the cam or gearing. Basicly want to see how far I can push this little cam. I know one thing I will probably have the fastest smallest cammed car in relation to everyone else. Eventually I will run a larger cam and make a few changes. This started as my daily driver, but no I finally have a truck again!
__________________
10.91 at 122 H/C stock block N/A
|
02-27-2014, 05:39 PM | #13 |
Drives: 2010 aqua blue SS/RS M6 Join Date: Feb 2010
Location: plainfield, IL
Posts: 2,706
|
Anyone have an opinion on cams? I would actually like to keep the 3.45s so I was thinking about something like this.
Cam now is 218/228. 112 Going to a 222/234 110 If I keep the gearing power has to come in fast and snappy. I could also loosen stall up to 3800 if needed.
__________________
10.91 at 122 H/C stock block N/A
|
02-27-2014, 05:45 PM | #14 |
Writer
Drives: 2010 SS / 1967 Camaro Join Date: May 2009
Location: Chicago, IL
Posts: 7,216
|
I kinda like how your car runs now, though it didn't 60 that hard the last time you were out at Byron. But I think you have a bunch more in it.
__________________
PROJECT HEAVY CHEVY
Camaro Now: Mods for the Masses Part I | Part II 13.15@106 1.95 | 100% Stock 12.37@112 1.85 | + Kooks Headers/Cats + 20" 555R + CAI + BW TB + UDP + Tune 12.06@113 1.70 | + CD 3200 + 18" NT05R + RCR Intake + NE OTR + GPI Tune 11.84@115 1.59 | + 3.91s + Race Star 17x7 Fronts 10.90@125 1.47 | + GPI VVT Cam + BW Ported Heads + CD 3800 |
|
|
Thread Tools | |
|
|