05-11-2012, 02:26 PM | #1 |
what happened?
I had a magnaflow axle back installed today(it sounds good) also replaced the stock air filter with a k&n when i started the car i had a check engine light for about a 1/2 hour then after shutting the car off a few times and letting it sit the engine light went out,is this normal because the computer had to reset?
|
|
05-11-2012, 03:25 PM | #2 |
what happened
should of did 1 thing at a time,was it the k&n or the exhaust
|
|
05-11-2012, 03:27 PM | #3 |
Account Suspended
Drives: 2012 Camaro 1SS Black Coupe Join Date: May 2012
Location: Houston
Posts: 1,091
|
This makes sense to me. I had this issue on a few of my cars in the past and I believe it does just have to relearn the new setup.
|
05-11-2012, 03:34 PM | #4 |
Account Suspended
Drives: 2012 Camaro 1SS Black Coupe Join Date: May 2012
Location: Houston
Posts: 1,091
|
|
05-11-2012, 03:56 PM | #5 |
car runs fine and engine light is out,so like posted i would think the ecu compensated,but has anyone done this,maybe go back to stock filter even though i think with a exhaust that lets more air should have more air in
|
|
05-11-2012, 04:24 PM | #6 |
The maf sensor probably wasn't connected correctly. I have read in other threads that if you put it back together incorrectly check engine light will light up...
|
|
|
|
|
|