05-18-2014, 06:35 PM | #211 |
Drives: 2010 Camaro 2SS/RS RJT, 6speed Join Date: May 2011
Location: South Florida
Posts: 887
|
It's the cup holder edge lit kit from Diode dynamics.
I made a y splitter connector for the abl under the center console gauges. I ran a length of those with the GM Delphi connectors to the power and ground wires for the diode dynamics kit. It tAkes one small hole per cup holder (2 holes total). Connect the power and ground and you're good to go. Put center console back together...
__________________
2010 Camaro 2SS/RS, LS3 - 6 speed. Mods, Magnaflow exhaust with resonator delete. ******** 12" stealth box subwoofer kit, Kicker 400 mono amp, JL XD 400/4 amp.
|
03-17-2017, 11:12 AM | #212 |
RJTSimon
Drives: 2011 RJT Camaro 1LT Join Date: Mar 2017
Location: Detroit
Posts: 1
|
What did you use to connect the the two leds together ?
And what gauge size t-tap connecter did you use? |
03-31-2017, 05:51 PM | #213 |
Drives: 2011 Camaro SS Vert. Join Date: Aug 2016
Location: CA
Posts: 79
|
Who sell this kit, I wan't one.
|
|
|
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Installed full dash and doors ABL, foot lighting with custom cup holder switch plate! | CamaroC-17 | Camaro Photos | Spyshots | Video | Media Gallery | 23 | 02-06-2013 09:45 PM |
DIY add light to inside door handle | overhaulengines | Camaro DIY & HOW-TO instructions & discussions | 32 | 07-21-2011 09:58 PM |
DIY custom ABL | BlueSteele | Camaro DIY & HOW-TO instructions & discussions | 5 | 02-07-2011 01:05 AM |
ABL lighting and Footwell Light Install? | JProberts | USA - Mid-Atlantic | 3 | 02-25-2010 10:17 PM |