You are browsing camaro5 
 |
|
03-29-2011, 03:10 PM
|
#1 |
|
Account Suspended
Drives: 2011 RJT 1SS Join Date: Apr 2010
Location: Fort Lewis, Washington
Posts: 730
 |
Airbag removal/diagram
Does anyone have a good diagram of the driver/passenger overhead curtain bags and side airbags? I need to remove them because my 8pt cage is going to interfere.
|
|
|
|
03-29-2011, 03:47 PM
|
#2 |
 Drives: 2010 Camaro 1LT, 2006 Ford Mustang Join Date: Mar 2011
Location: Minsk, Belarus
Posts: 14
|
Just a general procedures that i know:
1. disconnect negative batt cable 2. wait a couple of mins, try to start a car (so that remaining electricity goes away) 3. remove side A-pillar trim (i belive it just pops off) you should see the side airbag, and i think it's just bolt on... But of you leave it like that you gonna get SRS error. To avoid that - you must install the resistor between contacts. 2-4 kOhm if i'm not mistaken. |
|
|
|
|
06-20-2011, 10:32 PM
|
#3 |
|
Slow Turtle
Drives: 2011 1SS Join Date: Jun 2011
Location: Manhattan, KS
Posts: 1,123
|
TTT. Cant figure out how to remove the silver spider clips that hold these bastards to the frame. They're metal and odd looking. Three Per side. Help!
|
|
|
|
|
06-21-2011, 11:05 PM
|
#4 |
|
Slow Turtle
Drives: 2011 1SS Join Date: Jun 2011
Location: Manhattan, KS
Posts: 1,123
|
Crickets. Anyone have a GMLan subscription that can print out this section?
|
|
|
|
|
06-26-2011, 06:01 PM
|
#5 |
|
Slow Turtle
Drives: 2011 1SS Join Date: Jun 2011
Location: Manhattan, KS
Posts: 1,123
|
up
|
|
|
|
|
06-26-2011, 06:06 PM
|
#6 |
|
knows 2 facts about ducks
Drives: ...and they're both wrong Join Date: Aug 2009
Location: The HMS Invincible
Posts: 25,072
|
Are you talking about the little black clips that hold the trim panel in place? When I did my C pillars you just had to slide the clip up a little bit, push on it and then pull it out.
__________________
 |
|
|
|
|
06-26-2011, 07:18 PM
|
#7 |
|
Slow Turtle
Drives: 2011 1SS Join Date: Jun 2011
Location: Manhattan, KS
Posts: 1,123
|
No, the metal spider clips that hold the airbag netting to the a-pillar chassis member. They're unlike any clip I've ever seen before. I got them out by prying, but no idea how to remove them without totally mangling them.
|
|
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Passenger airbag sensor issue? | daveagogo1 | Camaro Issues / Problems | Warranty Discussions | TSB and Recalls | 34 | 04-09-2019 03:36 PM |
| AIRBAG SERVICING!? | Lydon | 5th Gen Camaro SS LS LT General Discussions | 16 | 04-29-2011 01:31 PM |
| Airbag light | Juls62 | Camaro Issues / Problems | Warranty Discussions | TSB and Recalls | 13 | 07-14-2010 09:29 AM |
| Anybody else had a service airbag soon pop up?? | 1SS/RSCamaro2010 | 5th Gen Camaro SS LS LT General Discussions | 7 | 04-04-2010 05:28 PM |
