You are browsing camaro5 
 |
|
09-24-2017, 06:55 AM
|
#1 |
 Drives: 2011 ss Join Date: Sep 2017
Location: Entice nc
Posts: 9
|
2012 ss with mrr 1le wheels lowering questions
I have a 2012 ss I just put the mrr 1le wheels 20x10& 20x11 factory spec and was wanting to lower 1.25 inches all around. Just wanting to know if it would be ok to do so and if anyone has done this with this set up
|
|
|
|
09-24-2017, 08:54 AM
|
#2 |
          
Drives: 2010 2SS/RS Join Date: Dec 2009
Location: Clarksville Tennesse.
Posts: 6,062
|
Just ask in the 1LE model specific section I believe those guys do it all the time. I have a set of Gen 6 1LE wheels which run 30s vs 35 aspect ratio from the 5th gen, so I'll be looking at a 1 inch drop instead.
__________________
Orange Krush II
1LE Front sway bar, Splitter, shocks and struts, Z28 dual mode mufflers, Intake, UCA Bushings, and Toresen 3.91 Diff. 1 piece DSS Drive Shaft, ZL1/C7 Calipers, and 32mm JPSS Rear Bar. ASC race spec splitter and wicker. 6th Gen M017 Wheels. Stainless Works 1 7/8 LTs. DSE and PAFDT Suspension components. |
|
|
|
|
10-01-2017, 08:01 PM
|
#3 |
Drives: 2013 1SS 1LE Join Date: Jun 2016
Location: Ixonia wi
Posts: 1,456
|
H&R 1.25 drop springs. 285 35 in the front, 305 35 in the rear...I love it!
__________________
2013 1le- Katech 416 short block, TSP custom grind cam, LOD intake, cnc heads by F.ED., Nick William's 102mm T.B., CORN fed, Pedders coilovers. Performance street alingnment by Justin at Lake Country Alignment and dyno tune by Late Model Throttle.
603 h.p. 495 ft lbs tq. |
|
|
|
|
|
|
|
 |
|
|
