11-27-2010, 01:05 PM | #995 |
Sold car...
Drives: 2010 Rally Yellow 2SS/RS #37115 Join Date: Oct 2009
Location: Manalapan, New Jersey
Posts: 2,019
|
NO puller needed....just remove torx bolt and pull....
__________________
Build Thread
ECS Novi 1500 Supercharged, LS3 conversion, Small blower cam, Alky Meth injection, 3:45 rear, BMR Suspension parts, 1LE Sways, Billy Boat ZL1 dual mode exhaust. |
11-27-2010, 01:06 PM | #996 |
Sold car...
Drives: 2010 Rally Yellow 2SS/RS #37115 Join Date: Oct 2009
Location: Manalapan, New Jersey
Posts: 2,019
|
Any tips on getting pad out once everything is unbolted....Mine is being stubborn...
__________________
Build Thread
ECS Novi 1500 Supercharged, LS3 conversion, Small blower cam, Alky Meth injection, 3:45 rear, BMR Suspension parts, 1LE Sways, Billy Boat ZL1 dual mode exhaust. |
11-27-2010, 01:19 PM | #997 |
|
just remove center bolt. but it is torx. A tap with a nylon hammer to the center shaft while pulling on the steering wheel should pop it off. I'm pulling the column as a whole unit.
Last edited by lionssfan; 11-27-2010 at 01:34 PM. |
11-27-2010, 04:31 PM | #998 |
Live for On Ramps!
Drives: 2010 Camaro/2LT/RS/T.F./6M "naomi" Join Date: Feb 2010
Location: Phoenix
Posts: 185
|
Nope didn't need one.... left the bolt in a couple of threads, steering wheel came right off with a slight pull, and the bolt whack me in the face, air bag wires caught on the wheel and broke the SIR coil. Chevy dealer had one in stock, only 30 bucks so a cheap learning experience.......so far. Dash is out and starting on the HUD install. Next time 4 or five threads on that steering bolt!
Also on the communications module and battery, which is mounted above the glove compartment, you can slide the main module (towards the rear of the car) enough to remove the 10mm bolt that holds the bracket that holds the module and battery. (There is actually a second bolt, 10mm at the passenger side front, towards engine compartment, of the backup battery) Bracket slides toward engine compartment off of metal tab, and than can be lower down onto the glove compartment hinge rail, untill you remove the two 13 mm bolts that hold the bottom of the passenger side air bag. After the two air bag bolts are removed, you can temporarily put comm module and battery back in position. Put one of the two 10mm bolts back in just to hold it in place. This way your not pulling the backup battery or any other connectors off of the module. Not sure how much this will save on the backend.... Joe Last edited by STINGS; 11-27-2010 at 10:48 PM. |
11-27-2010, 05:17 PM | #999 |
2SS
Drives: 2016 2SS, Red Garnet Tint Join Date: Nov 2008
Location: Imperial, CA
Posts: 1,343
|
First off, there are now Two (2) 2010 Camaros on the West Coast with HUD now installed and working. Ofer's 2SS and My 2LT/RS. As far as the Steering Wheels are concerned, on both of our cars we HAD to use a steering wheel puller to REMOVE the steering wheel, also it should be remembered both Ofer's car and Mine are Early Order Activity Cars (R6P). The rubber hammer idea did not work on either cars.
Walt B.
__________________
2016 Camaro 2SS
2005 Dodge Magnum R/T (Yes it has a Hemi) 1987 Camaro RS (California Special) - For Sale Gen6, 2016 Camaro 2SS, Red Garnet Tint (with Silver Rally Stripes) Ordered: 2-12-2016 TPW: 3-7-2016 Built: 3-7-2016 VIN 1G1FH78G0157626 Delivered: 4-26-2016 Last edited by WCoolBreeze; 11-27-2010 at 06:32 PM. |
11-27-2010, 06:01 PM | #1000 |
11-27-2010, 06:28 PM | #1001 |
Sold car...
Drives: 2010 Rally Yellow 2SS/RS #37115 Join Date: Oct 2009
Location: Manalapan, New Jersey
Posts: 2,019
|
Ok East coast NJ has another HUD.....
Wheel torx size is a 45 or 47 close up dash view Only damage was to hood release, I broke the tab trying to release it. So for now its in with a dab of glue to keep from rattling...
__________________
Build Thread
ECS Novi 1500 Supercharged, LS3 conversion, Small blower cam, Alky Meth injection, 3:45 rear, BMR Suspension parts, 1LE Sways, Billy Boat ZL1 dual mode exhaust. Last edited by Rcfiddy1; 11-28-2010 at 02:25 PM. |
11-27-2010, 06:32 PM | #1002 |
2SS
Drives: 2016 2SS, Red Garnet Tint Join Date: Nov 2008
Location: Imperial, CA
Posts: 1,343
|
Congrats, now we are two for two, two East and Two West.
Walt B.
__________________
2016 Camaro 2SS
2005 Dodge Magnum R/T (Yes it has a Hemi) 1987 Camaro RS (California Special) - For Sale Gen6, 2016 Camaro 2SS, Red Garnet Tint (with Silver Rally Stripes) Ordered: 2-12-2016 TPW: 3-7-2016 Built: 3-7-2016 VIN 1G1FH78G0157626 Delivered: 4-26-2016 |
11-27-2010, 06:41 PM | #1003 |
|
is that as sharp as it gets or did you tune it to get it a bit clearer?
__________________
THE "MENACE"
|
11-27-2010, 07:01 PM | #1004 |
Drives: 2010 Camaro 2SS/RS Black, 6M Join Date: Oct 2010
Location: Northern Minnesota
Posts: 17
|
I suppose I should attempt mine since I'm in the Midwest... but I've been too busy cleaning snow lately. The Camaro is all tucked away (covered) in my garage. Would you guys advise buying any service manuals for this? Someone awhile ago said "NO" but I don't want to mess things up.
Good Job guys! I'll have to heat my garage up sometime soon and start on mine! |
11-27-2010, 07:22 PM | #1005 |
Live for On Ramps!
Drives: 2010 Camaro/2LT/RS/T.F./6M "naomi" Join Date: Feb 2010
Location: Phoenix
Posts: 185
|
Well it is dark, and now I know how walt and ofer felt, I'm hungry!! Will have to wait till tomorrow to put the dash pad back in, so hopefully it I can talk my brother to come on down and help put the dash pad back in, so we can get it finished since I need to get to work on Monday!. Just a couple of pic's. Took one from the drivers side, since Guskd was from the passenger side, and yep another yellow one.
To bad they hide the "Aw Sh#t" bar behind the dash pad! |
11-27-2010, 08:09 PM | #1006 |
Sold car...
Drives: 2010 Rally Yellow 2SS/RS #37115 Join Date: Oct 2009
Location: Manalapan, New Jersey
Posts: 2,019
|
Looks like you left your seats in. I am 6'2" and there was no way I was laying under dash with seats in.
__________________
Build Thread
ECS Novi 1500 Supercharged, LS3 conversion, Small blower cam, Alky Meth injection, 3:45 rear, BMR Suspension parts, 1LE Sways, Billy Boat ZL1 dual mode exhaust. |
11-27-2010, 08:10 PM | #1007 | |
ZEUSS
|
Quote:
|
|
11-27-2010, 08:12 PM | #1008 |
Sold car...
Drives: 2010 Rally Yellow 2SS/RS #37115 Join Date: Oct 2009
Location: Manalapan, New Jersey
Posts: 2,019
|
Thats it as far a clarity goes. There is a little bit of ghosting but overall its not bad at all. I will get new windshield later when I get too many chips.
__________________
Build Thread
ECS Novi 1500 Supercharged, LS3 conversion, Small blower cam, Alky Meth injection, 3:45 rear, BMR Suspension parts, 1LE Sways, Billy Boat ZL1 dual mode exhaust. |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New Camaro Exterior and Interior Stainless Steel Trim Parts from RPI Designs! | RPI Designs | Cosmetics and Lighting Modification Discussions | 36 | 04-02-2020 05:32 PM |
February 2010 Camaro production & sales figures. Tops Mustang for 9th straight month! | Tran | 5th Gen Camaro SS LS LT General Discussions | 52 | 03-03-2010 09:39 PM |
DEALER ONTARIO CANADA WE SHIP ANYWHERE IN CANADA 2010 CAMAROS FOR SALE IN STOCK NOW! | dz | Dealer Camaros for Sale | 0 | 03-03-2010 05:43 PM |
Zex Nitrous System for 2010 Camaro SS @ BMC Performance! | Kris@BMCPerformance | Forced Induction | 2 | 02-18-2010 06:59 PM |
2010 Chevrolet Camaro makes finalist list for 2010 World Car Design of the Year | Tran | 5th Gen Camaro SS LS LT General Discussions | 37 | 02-17-2010 04:22 PM |