12-23-2009, 10:48 AM | #1 |
question about ARH LTs?
I just finish installing ARH 1 7/8 LTs no cats on my camaro.after finishing the installation I noticed very little air is coming out where the pipes meets the factory pipes of the OEM muffler is this normal?I tighten the bolts as far as it goes but still very little air is coming out,one of the guys mentioned I should drive it for few days the carbon and other deposits will close these small gaps is this true?
__________________
recieved 7-10-09 2010 camaro black 2ss/RS/6m
|
|
12-23-2009, 10:53 AM | #2 |
Drives: 2013 Camaro ZL1 Join Date: Apr 2009
Location: El Paso, Tx
Posts: 688
|
I dont know about the carbon deposits and such, but I do know that the metal will heat up as you drive and change shape, drive it around for a week or two then tigthen again.
__________________
Devliered July 20, 2012
|
12-24-2009, 12:02 PM | #3 |
I hope that's all it will take.thanks for your help
__________________
recieved 7-10-09 2010 camaro black 2ss/RS/6m
|
|
12-26-2009, 03:11 PM | #4 |
Drives: 2SS w/ ZZ427 Package!! Join Date: Oct 2008
Location: Pittsburgh, PA
Posts: 2,700
|
I would sya drive the car for a little while and make sure everything is good and hot....then tighten those clamps back up. i fyou have everything lined up correctly it will seal up with no problems.
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Project “ZEUSS” | khislop007 | Member Car Journals | 129 | 10-09-2015 08:26 AM |
ARH 1 3/4 or 1 7/8 cats or no cats?? | Q8Y | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 27 | 10-30-2009 12:20 PM |
Anyone have MBRP with ARH LTs? | caverman | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 1 | 10-13-2009 06:27 PM |
Got my ARH LT's and Borla installed on my LS3 | khislop007 | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 10 | 10-08-2009 03:27 PM |
Anyone have ARH LT's & SLP LM II's installed? | ssmike | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 10 | 09-01-2009 11:21 AM |