Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Gen5DIY
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > General Camaro Forums > 5th Gen Camaro SS LS LT General Discussions

5th Gen Camaro SS LS LT General Discussions General 5th generation Camaro topics not covered by other subforums.

Reply
 
Thread Tools
Old 03-29-2011, 03:10 PM   #1
Ovenmitt
Account Suspended
 
Drives: 2011 RJT 1SS
Join Date: Apr 2010
Location: Fort Lewis, Washington
Posts: 733
Send a message via AIM to Ovenmitt
Airbag removal/diagram

Does anyone have a good diagram of the driver/passenger overhead curtain bags and side airbags? I need to remove them because my 8pt cage is going to interfere.
Ovenmitt is offline   Reply With Quote
Old 03-29-2011, 03:47 PM   #2
mortefer
 
Drives: 2010 Camaro 1LT, 2006 Ford Mustang
Join Date: Mar 2011
Location: Minsk, Belarus
Posts: 14
Just a general procedures that i know:
1. disconnect negative batt cable
2. wait a couple of mins, try to start a car (so that remaining electricity goes away)
3. remove side A-pillar trim (i belive it just pops off)

you should see the side airbag, and i think it's just bolt on...

But of you leave it like that you gonna get SRS error. To avoid that - you must install the resistor between contacts. 2-4 kOhm if i'm not mistaken.
mortefer is offline   Reply With Quote
Old 06-20-2011, 10:32 PM   #3
DietCoke
Slow Turtle
 
DietCoke's Avatar
 
Drives: 2011 1SS
Join Date: Jun 2011
Location: Richmond Hill, GA
Posts: 1,119
Send a message via AIM to DietCoke
TTT. Cant figure out how to remove the silver spider clips that hold these bastards to the frame. They're metal and odd looking. Three Per side. Help!
DietCoke is offline   Reply With Quote
Old 06-21-2011, 11:05 PM   #4
DietCoke
Slow Turtle
 
DietCoke's Avatar
 
Drives: 2011 1SS
Join Date: Jun 2011
Location: Richmond Hill, GA
Posts: 1,119
Send a message via AIM to DietCoke
Crickets. Anyone have a GMLan subscription that can print out this section?
DietCoke is offline   Reply With Quote
Old 06-26-2011, 06:01 PM   #5
DietCoke
Slow Turtle
 
DietCoke's Avatar
 
Drives: 2011 1SS
Join Date: Jun 2011
Location: Richmond Hill, GA
Posts: 1,119
Send a message via AIM to DietCoke
up
DietCoke is offline   Reply With Quote
Old 06-26-2011, 06:06 PM   #6
The Stig
knows 2 facts about ducks
 
The Stig's Avatar
 
Drives: ...and they're both wrong
Join Date: Aug 2009
Location: The HMS Invincible
Posts: 26,680
Are you talking about the little black clips that hold the trim panel in place? When I did my C pillars you just had to slide the clip up a little bit, push on it and then pull it out.
__________________
Click to view my build thread
The Stig is offline   Reply With Quote
Old 06-26-2011, 07:18 PM   #7
DietCoke
Slow Turtle
 
DietCoke's Avatar
 
Drives: 2011 1SS
Join Date: Jun 2011
Location: Richmond Hill, GA
Posts: 1,119
Send a message via AIM to DietCoke
No, the metal spider clips that hold the airbag netting to the a-pillar chassis member. They're unlike any clip I've ever seen before. I got them out by prying, but no idea how to remove them without totally mangling them.
DietCoke is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Passenger airbag sensor issue? daveagogo1 Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 15 07-24-2014 09:26 PM
AIRBAG SERVICING!? Lydon 5th Gen Camaro SS LS LT General Discussions 16 04-29-2011 01:31 PM
Airbag light Juls62 Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 13 07-14-2010 09:29 AM
Anybody else had a service airbag soon pop up?? 1SS/RSCamaro2010 5th Gen Camaro SS LS LT General Discussions 7 04-04-2010 05:28 PM


All times are GMT -5. The time now is 11:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.