Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
BeckyD@RodgersChevrolet
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Specific Models / Packages > Camaro Convertible Forum

Camaro Convertible Forum For all Camaro Convertible specific discussions

Reply
 
Thread Tools
Old 07-17-2011, 10:17 PM   #1
QuiksilverHg
 
QuiksilverHg's Avatar
 
Drives: 2SS, RS Package, Imperial Blue
Join Date: Jun 2011
Location: Corpus Christi, TX
Posts: 37
Roll down and back up

I got this message twice today in my dash display.

Open the passenger window then close it

Or something like that. Anyone had this before? Anyone know why I might be getting it?

The top was down before I noticed the message, I rolled the window down and back up and it didn't go away until I hit the menu-select toggle. It didn't reappear that drive, but the next time I started it up it did the same thing. Haven't noticed anything weird with the window except that it wouldn't auto-roll up while the message was there. And this morning when I got it home I noticed that the passenger window 'seemed' to come down more than normal when I opened and closed the door.

Anyone have any ideas?
QuiksilverHg is offline   Reply With Quote
Old 07-17-2011, 10:23 PM   #2
nukemustang
 
nukemustang's Avatar
 
Drives: 2011 SIM 1SS/RS Vert, 14 Raptor
Join Date: Feb 2010
Location: Summerville, SC
Posts: 239
should just be the windows going through the self indexing process. I think it is what calibrates how far the window should go down when the door opens and then how far to go back up when it shuts.
__________________
2011 Silver Ice Metallic 1SS/RS+ Convertible. Completed modifications so far: installed factory HUD, deleted AFM/DOD, Dynatech LT coated headers with high flow cats, Solo Cat back exhaust, CAI inc. intake, Vmax ported TB, SIM quarter flares/splash guards, steering wheel radio controls, PDIM iPod interface in center console, RX catch can, JRE cold air scoop, windshield washer bottle relocation.
nukemustang is offline   Reply With Quote
Old 07-18-2011, 07:57 AM   #3
EM1/SS
 
Drives: 11 2SS/RS M6 vert
Join Date: Dec 2010
Location: Western PA
Posts: 510
I got the message once. No matter how many times I put the window down and up it would not clear. My window stopped indexing. I had to look up how to reset the window. You un-clip the wires going to the window with the car in run but not started. After at least one minute hook it back up. I did it about three weeks ago and it hasn't come back.
__________________
Vararam intake, Borla S-Type cat back, BMR/ Pedders Suspension, Kooks stepped LT's, GM 3.91, and JRE tune.
EM1/SS is offline   Reply With Quote
Old 07-18-2011, 10:40 AM   #4
J Wilkins
 
J Wilkins's Avatar
 
Drives: 2012 Panther #4
Join Date: Jul 2011
Location: Bedford, KY
Posts: 64
Me also

Had it happen several times, does not like to have the windows/top put down with one of the doors open, I am bad about that and that seems to be the trigger.
Solution for me is to have the top up, do the windows up and down until it's happy, and to avoid, just shut my door before putting the top down, have the windows up and then let the master switch put the windows down as the top goes down.

Pain, but it eliminates the systems confusion.
J Wilkins is offline   Reply With Quote
Old 07-18-2011, 10:57 AM   #5
OrangeVert
"Catharine"
 
OrangeVert's Avatar
 
Drives: '11 2SS/RS LS-3 IOM/IO vert
Join Date: Mar 2011
Location: Southern NH
Posts: 1,752
Thanks - good info! Haven't had it happen yet, usually reach inside thru the driver's door window opening to put the top down. Old habit, I stand outside while putting the top down 'cause I used to have to adjust my old ones to keep them from being pinched.
__________________
OrangeVert is offline   Reply With Quote
Old 07-18-2011, 05:45 PM   #6
Chevrolet Customer Svc


 
Chevrolet Customer Svc's Avatar
 
Drives: GM Vehicles
Join Date: Jun 2010
Location: Michigan
Posts: 8,830
The steps for reprogramming our windows are in the manual in section 2 page 16.

To program each front window,
follow these steps:

1. With the ignition in ON/RUN,
close all doors.

2. With the window partially open,
pull the power window switch up
until the window is fully closed.

3. Repeat step 2 on all remaining
windows.

The windows are now
reprogrammed.

I hope this information helps you. Let me know if this works for you!

Jeff Morris, Chevrolet Customer Service
Chevrolet Customer Svc is offline   Reply With Quote
Old 07-18-2011, 10:21 PM   #7
EM1/SS
 
Drives: 11 2SS/RS M6 vert
Join Date: Dec 2010
Location: Western PA
Posts: 510
This didn't work for me. I had to reset my window by pulling the power cable.


Quote:
Originally Posted by Chevrolet Customer Svc View Post
The steps for reprogramming our windows are in the manual in section 2 page 16.

To program each front window,
follow these steps:

1. With the ignition in ON/RUN,
close all doors.

2. With the window partially open,
pull the power window switch up
until the window is fully closed.

3. Repeat step 2 on all remaining
windows.

The windows are now
reprogrammed.

I hope this information helps you. Let me know if this works for you!

Jeff Morris, Chevrolet Customer Service
__________________
Vararam intake, Borla S-Type cat back, BMR/ Pedders Suspension, Kooks stepped LT's, GM 3.91, and JRE tune.
EM1/SS is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:14 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.