![]() |
|
|||||||
| Homepage | Garage | Wiki | Register | Members List | Social Groups | Calendar | Search | Today's Posts | Mark Forums Read |
| Camaro DIY & HOW-TO instructions & discussions All DIY projects & discussions |
![]() |
|
|
Thread Tools |
|
|
#1 |
![]() |
DIY for changing the shift indicator light on an automatic??
I did a search but could not locate this mod, anyone do this already? Thanks.
|
|
|
|
|
|
#2 |
![]() ![]() ![]() Drives: 2011 RJT Camaro LT2 RS auto shift Join Date: Dec 2011
Location: Washington state
Posts: 1,116
|
Hurst-Comp-Shifter-2010-Camaro-inst.pdf
This was the steps that I used. It is for changing the shift plate to a a Hurst plate. Use steps 1 to 10 and disregard 11 on. Get you some very small diameter shrink tubing so you can insulate the led leads. After putting the led into the holder you can solder solder the connector. They are a resistor on the yellow wire but I do not now it value. I used my own resistor. After you put in your new led reverse the procedure.
__________________
Caddy Last edited by Caddyroger; 03-11-2012 at 03:47 PM. |
|
|
|
![]() |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Diagnostic Trouble Codes (DTCs) for OBD II equipped GM vehicles | steeleshark2 | Tuning / Diagnostics -- engine and transmission | 7 | 03-15-2013 09:03 PM |
| AUTOMATIC with TAP SHIFT... | stymie | Camaro ZL1 Forum - ZL1 Specific Topics | 74 | 02-24-2012 06:17 AM |
| Raptor Shift Lights @ KY SPEED | Brody | Audio / Visual / Electronics/ Gauges / Nav | 2 | 12-16-2011 07:20 AM |
| Super Sale on Raptor Shift Lights @ KY SPEED | FRCBobby | Audio / Visual / Electronics/ Gauges / Nav | 44 | 11-25-2011 10:34 AM |
| Did Camaro (automatic) reviewers use tap shift ? | trudawg660 | 5th Gen Camaro SS LS LT General Discussions | 30 | 11-09-2010 07:55 PM |