![]() |
|
|||||||
| Homepage | Garage | Wiki | Register | Members List | Social Groups | Calendar | Search | Today's Posts | Mark Forums Read |
| Camaro V6 LFX Engine, Exhaust, and Bolt-Ons For all LFX related parts |
![]() |
|
|
Thread Tools |
|
|
#26 | |
![]() Drives: 2012 Chevrolet Camaro 2LS Join Date: Jan 2010
Location: Coral Springs, FL
Posts: 317
|
Quote:
__________________
|
|
|
|
|
|
|
#27 |
![]() Drives: 2012 Camaro LFX,CAI,DynomaxVT,RX CC Join Date: Feb 2012
Location: So Cal Mtns
Posts: 487
|
The quality looks very good...does the top seal against the hood to stop from sucking in hot air coming thru the radiator? If you arent sure you could put grease along the top, close the hood and see if the grease is disturbed and where its imprinted on the hood?
I like the CAI intake because top is sealed and the only air that can enter if from the front. Either way you got a smoking deal! Good job |
|
|
|
|
|
#28 |
|
Camaros Of Northwest Ohio
Drives: 2010 IOM 1LT, 1974 Corvette Join Date: May 2010
Location: Toledo, OH
Posts: 398
|
Not possible, K&N isn't even a brand name, apparently.
![]()
__________________
Camaros Of Northwest Ohio is on Facebook!
http://www.facebook.com/#!/pages/Nor...93610744003149 |
|
|
|
|
|
#29 | |
![]() Drives: 2012 2LT 45th Anniversary Join Date: Jun 2012
Location: Indiana
Posts: 35
|
Quote:
It certainly looks like it seals (haven't greased it). When I eyeball it, it looks even with the existing weatherstripping that goes along the front edge of the car...and I'm assuming, er, presuming that weatherstripping makes a good seal!
|
|
|
|
|
|
|
#30 |
![]() Drives: 2012 2LT 45th Anniversary Join Date: Jun 2012
Location: Indiana
Posts: 35
|
|
|
|
|
|
|
#31 |
![]() Drives: 2012 Silver Ice 1LT Join Date: Oct 2011
Location: Yunkjun Zity, UrEgun
Posts: 113
|
It looks like a cheap Roto-Fab rip-off. After my last K&N install which led to 6 years of burning cats from the factory over-oiled filter and intermittent CEL, I'll pass.
![]() 5thGen2LT: you should get the oil breather cap, and remove the clean-side oil tube from your engine and cap the ends off. At WOT, a backflow condition is created which can suck oil out of the valve cover and into the intake. Removing the line prevents this, while the breather insures a separate air source without robbing from your intake feed.
__________________
Mods: VMax PTB Green Filter Solo Mach X-LFX J-Pipe Cat-Back Exhaust Heated Outside Mirrors BA GTA 1000M Amp BA G3 12" Subwoofer Pioneer TS-T15 Tweeters RX Catch Can RX Oil Breather Cap 4-Pack Gauges Drake Bowtie Delete De-labeled Visors Gorilla Wheel Locks Unofficial Cargo Net Ignition Keyed Locking Gas Cap Satin Billet Door Locks Yzk Mud Flaps Cup Holder Accessory Switch
Future Mods: ZL1 Front Swaybar & Endlinks Full-Size Spare Front Camera |
|
|
|
|
|
#32 | |
![]() Drives: 2012 Chevrolet Camaro 2LS Join Date: Jan 2010
Location: Coral Springs, FL
Posts: 317
|
Quote:
That sucks about the 6 years, and im sorry. As far as K&N I have used them for many years in other cars (v6 camaro 4th gen, and v8 camaro 4th gens) and they worked perfect, no issues.
__________________
|
|
|
|
|
|
|
#33 | |
![]() Drives: 2012 Chevrolet Camaro 2LS Join Date: Jan 2010
Location: Coral Springs, FL
Posts: 317
|
Quote:
Thanks for getting back to me via pm. I just ordered this intake, $255 shipped from http://store.newlevelmotorsports.com/ . Can't wait for it to get here! I have been waiting on a k&n intake since I first drove my Camaro of the lot.
__________________
|
|
|
|
|
|
|
#34 |
![]() Drives: 2012 Camaro 2Lt RS Ashen Gray Join Date: Apr 2012
Location: New york
Posts: 24
|
Hey i wanted to get an k&n intake for my 2012 v6 so i ordered it online from phastek performance and then a day later i got a call saying that there has been a recall on there intakes for the 2012 v6 camaros, has anyone heard of this recall???
|
|
|
|
|
|
#35 | |
![]() Drives: 2012 Chevrolet Camaro 2LS Join Date: Jan 2010
Location: Coral Springs, FL
Posts: 317
|
Quote:
I ordered mine on July 1st for a website (forget the name off the top of my head) and it isn't here yet. I called K&N and they said they will ship out this friday (tomorrow). He didnt really say why they were shipping out this late. I guess a recall would make sense?
__________________
|
|
|
|
|
|
|
#36 |
![]() Drives: 2012 2LT 45th Anniversary Join Date: Jun 2012
Location: Indiana
Posts: 35
|
hmmm, I certainly haven't heard anything yet. j0s394, funny you should mention that because I just happened to see this thread: http://www.camaro5.com/forums/showthread.php?t=229971 which shows Phastek Performance taking orders as of 07-10-12. Did the guy on the phone say what specifically the recall was about?
|
|
|
|
|
|
#37 |
![]() Drives: 2012 2LT 45th Anniversary Join Date: Jun 2012
Location: Indiana
Posts: 35
|
I do know that a bunch of places are backordered, though...?
|
|
|
|
|
|
#38 |
![]() Drives: 2012 Camaro 2Lt RS Ashen Gray Join Date: Apr 2012
Location: New york
Posts: 24
|
|
|
|
|
![]() |
| Thread Tools | |
|
|