Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
TireRack
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Engine | Drivetrain | Powertrain Technical Discussions > Forced Induction - V8

Forced Induction - V8 V8 Supercharger, turbo, nitrous discussions

Reply
 
Thread Tools
Old 06-05-2013, 06:38 PM   #1
11TexaSS
 
11TexaSS's Avatar
 
Drives: 2011RedJewel, FI
Join Date: Dec 2011
Location: San Antonio,TX
Posts: 685
Boost gauge?

Everyone running a boost gauge?? Which is better the avg?
11TexaSS is offline   Reply With Quote
Old 06-05-2013, 09:20 PM   #2
NOT URSS
 
NOT URSS's Avatar
 
Drives: 2010 2SS/RS Camaro
Join Date: Jul 2010
Location: St. Cloud, FL
Posts: 403
Send a message via AIM to NOT URSS
I have been using the AEM boost gauge.. looks good easy install
__________________
632RWHP/556RWTQ
NOT URSS is offline   Reply With Quote
Old 06-05-2013, 09:27 PM   #3
Mchlgrrsn
Stroked and blown
 
Mchlgrrsn's Avatar
 
Drives: 2010 LS3 2SS
Join Date: Dec 2012
Location: Bridgewater, NJ
Posts: 1,452
+1
Matches the dash well
Name:  image.jpg
Views: 375
Size:  87.1 KB
__________________
LME 416 LS3 shortblock/Callies Compstar 4340 4"crank/Callies 6.125 H beams rods/Wiesco 4.07 forged pistons/Cam Motion custom LS1/LME ported heads /maggie TVS2300/I West 8rib 10%OD /3.2 pulley/OD cog drive/JRE tensioner/ID850 /ADM dual fuel/Kooks LT 1 7/8/magna flow2.5 /cat delete/Roto Fab CAI /MGW short throw /SPEC super twin clutch/G Force built trans,carbon syncro rear shaft upgrade /DSS 9"single CF DS /Strange 3.70/31 spline trutrac/MT DR's/earls oil cooler /tuned KHC
Mchlgrrsn is offline   Reply With Quote
Old 06-05-2013, 09:31 PM   #4
Mchlgrrsn
Stroked and blown
 
Mchlgrrsn's Avatar
 
Drives: 2010 LS3 2SS
Join Date: Dec 2012
Location: Bridgewater, NJ
Posts: 1,452
Day shot
Name:  image.jpg
Views: 343
Size:  130.6 KB
__________________
LME 416 LS3 shortblock/Callies Compstar 4340 4"crank/Callies 6.125 H beams rods/Wiesco 4.07 forged pistons/Cam Motion custom LS1/LME ported heads /maggie TVS2300/I West 8rib 10%OD /3.2 pulley/OD cog drive/JRE tensioner/ID850 /ADM dual fuel/Kooks LT 1 7/8/magna flow2.5 /cat delete/Roto Fab CAI /MGW short throw /SPEC super twin clutch/G Force built trans,carbon syncro rear shaft upgrade /DSS 9"single CF DS /Strange 3.70/31 spline trutrac/MT DR's/earls oil cooler /tuned KHC
Mchlgrrsn is offline   Reply With Quote
Old 06-06-2013, 12:30 AM   #5
Kronix
HT5 Coast2Coast
 
Kronix's Avatar
 
Drives: 2014 C7 Stingray & 440HP Z71 Tahoe
Join Date: Nov 2011
Location: South Jersey & SoCal
Posts: 1,919
ProSports Evo Series, red & blue led matches interior perfectly
Attached Images
 
__________________
Kronix is offline   Reply With Quote
Old 06-06-2013, 04:02 AM   #6
11TexaSS
 
11TexaSS's Avatar
 
Drives: 2011RedJewel, FI
Join Date: Dec 2011
Location: San Antonio,TX
Posts: 685
All look nice!
11TexaSS is offline   Reply With Quote
Old 06-06-2013, 05:22 AM   #7
NOT URSS
 
NOT URSS's Avatar
 
Drives: 2010 2SS/RS Camaro
Join Date: Jul 2010
Location: St. Cloud, FL
Posts: 403
Send a message via AIM to NOT URSS
Name:  ImageUploadedByTapatalk1370514150.678596.jpg
Views: 278
Size:  51.3 KB
Name:  ImageUploadedByTapatalk1370514175.075111.jpg
Views: 282
Size:  47.2 KB
__________________
632RWHP/556RWTQ
NOT URSS is offline   Reply With Quote
Old 06-06-2013, 05:30 AM   #8
dynosteve
www.rdpstore.com

 
dynosteve's Avatar
 
Drives: 2010 SS Camaro Turbo
Join Date: Oct 2009
Location: Painesville Ohio
Posts: 3,309
Send a message via Yahoo to dynosteve
I prefer to run the aeroforce system which is a gauge that can handle any item that the pcm puts out through the OBD2 port
http://www.rdpstore.com/p-499-aerofo...or-gauges.aspx
__________________
www.rdpstore.com Ph: 440 358 5500 or 440 251 8571 SLP / Kooks / SCT / Diablosport / Cold Air Inductions / Whipple / Vortech / TruTrac /Edelbrock / Fore Innovations / DSS / Hayes / Turbonetics / Vredestein / Borla / Maganflow / Corsa / Stainless Works / Hotchkis / EBC / Magnuson / Airaid / Whiteline /Fore Innovations / Snow /Trickflow / Moroso / Hp Tuners / Brembo / Rotofab and much much more
dynosteve is offline   Reply With Quote
Old 06-06-2013, 06:38 AM   #9
dan0617
 
dan0617's Avatar
 
Drives: 2011 Inferno Orange SS Convertible
Join Date: Apr 2012
Location: Tyrone, PA
Posts: 622
Check out dynotunenitrous.com. Nice little square gauge that has boost and AFR split screen, or chose any 2 parameters and colors you want when you order it.
__________________
2011 SS IOM Vert. ECS Vortech 13.5 psi, Water/Meth, 125 shot, 2800 stall, LT headers, Zex 125 shot, Drag radials, Drag alignment. Details in Garage. I hack it up, Ted tunes it in.
dan0617 is offline   Reply With Quote
Old 06-06-2013, 10:44 AM   #10
Mr. Nasty
Emerald Coast Camaros
 
Mr. Nasty's Avatar
 
Drives: 2010 RS/SS Rally Yellow & 68 SS
Join Date: Dec 2012
Location: Woodville,FL.
Posts: 1,358
I will also be putting in boost and air/fuel gauges in mine.Mchlgrrsn looking at your average fuel at 10.9 MPG makes me feel a little better about my 11.8 MPG LOL
__________________
Best @ 586/525 =10.41 @ 133
Best so far @ 633/544 =10.36 @ 132
Mr. Nasty is offline   Reply With Quote
Old 06-06-2013, 12:31 PM   #11
patternpilot
 
patternpilot's Avatar
 
Drives: 2012 2SS/RS 05 Jag S type R
Join Date: Aug 2011
Location: Tri-Cities WA.
Posts: 595
I am running the Pro Sport Evo style like Kronx. I like the look and function of the gauges, but have found out that there is no way to get the AFR to data-log. I have had several conversations with Pro Sport and they tell me they are working on a module that will allow data logging but it is not available yet. The analog out-put from the current module is only to connect the wide-band sensor to the car's computer. Not sure what good that would do, but that is what they designed. If you need to data-log I would stay away from these for right now until they get their module up and running.
__________________
There's more to life than gas mileage

LS3, Whipple, Custom Comp Cam, springs, pushrods, timing set, CAI intake, Apex cold air scoop, Doug Thorley TRI-Y headers, Billet Custom Products baffled Valve covers, Mighty Mouse Catch can, ADM FPCM, ZL1 fuel pump, MSD boost-a-pump, Hex Vent hood vents, ProSport gauges(fuel pressure, AFR, Boost), Corsa, No Cats. Jannetty remote tuned, Pfadt trailing arms, all parts user installed. No Dyno yet. Manual trans. 3.45 gears.
patternpilot is offline   Reply With Quote
Old 06-07-2013, 08:35 AM   #12
11TexaSS
 
11TexaSS's Avatar
 
Drives: 2011RedJewel, FI
Join Date: Dec 2011
Location: San Antonio,TX
Posts: 685
Anyone have any experience with gauges from PLX Devices?
11TexaSS is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:09 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.