Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Gen5DIY
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Technical Camaro Topics > Suspension / Brakes / Chassis

Suspension / Brakes / Chassis All suspension, brakes and chassis discussions.

Reply
 
Thread Tools
Old 05-03-2014, 12:57 PM   #1
JBoy
 
Drives: '13 LFXv6
Join Date: Feb 2013
Location: Texas
Posts: 17
problems with eibach lowering springs

Just installed a set of eibach lowering springs on my 2013 v6 camaro. Install went really well but the front shocks arent sitting right. Under the hood on the single screw the bolt/washer sits higher than it did causing the top bolt and washer to be approximately 1/4 inch higher. In other words the top bolt and washer do not hold the shock in place and if i drive it it seems like it would bounce around. They were tourqued down to spec and was told i do not need to trim the bushings or anything for this install. Anyone have any ideas? I will try to get pictures later this afternoon once I get back home
JBoy is offline   Reply With Quote
Old 05-03-2014, 01:12 PM   #2
130R
Machine Washable.
 
130R's Avatar
 
Drives: Western Digital.
Join Date: Mar 2013
Location: Location. Location.
Posts: 557
If it looks like this, it's normal. You must not have noticed it before…
130R is offline   Reply With Quote
Old 05-03-2014, 01:22 PM   #3
JBoy
 
Drives: '13 LFXv6
Join Date: Feb 2013
Location: Texas
Posts: 17
It seemed like it was tight on it when i first took it off.... I figured like that the spring would bounce around going over a good bump or two?
JBoy is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:56 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.