Headlight Armor Lighting Protection and Smoked Taillight Kits Available

[ChadG]

Here is the best picture which illustrates how the vinyl is starting to separate from the headlight (you can see three small bubbles spaced along the upper right hand side of the headlight in this picture). Do you think it is going to get worse? Is there something I can do to fix it?

[HeadlightArmor]

Can't really tell, from the photo they look fine. I would keep using the vinyl cleaner / conditioner when you clear your car and you should be fine.

[ChadG]

Originally Posted by HeadlightArmor

Can't really tell, from the photo they look fine. I would keep using the vinyl cleaner / conditioner when you clear your car and you should be fine.

Yeah right now they are small, I'm just freaking out that they might start separating worse. Would heating/rewetting them help?

If I end up having to reapply a new set, I'm assuming I just heat them with a heat gun/hair dryer and slowly peel them off? In general how much adhesive is left on the plastic and how hard is it to get off? I have 3M adhesive remover I'm assuming that and Plexus are the way to go.

Hope these continue to last quite a while, I love the look and was happy to see photos of my car on your site!

[HeadlightArmor]

I have had several sets on various vehicles for a number of years and they help up great. Scorching Texas heat, long road trips, and winter skiing in the mountains.

As for removal - From the FAQ on the site.

Are they removable?
Yes they are fully removable but they can only be used once. Removal is straight forward. Start by warming the material a bit with a hairdryer and then pick at a corner with your fingers and then slowly peel off - making sure to hold onto the light firmly during the process.You may or may not have left over adhesive on the lens. Leftover adhesive can be rubbed off or carefully removed with an adhesive cleaner.

In practice I have seen some lights leave next to no adhesive on the light after removal, while other do leave some.

[ChadG]

Thanks, good to know! Worst case scenario is they start to separate and I need to put on a new set . . . I plan on keeping this car forever so I can imagine I'll probably go through a few sets of these over the life of the car. I get nothing but compliments all the time about the look, it's very clean. So keep up the good work, there will be people like me needing to buy these again from in you 10-15 years!

[AKAviking14]

Just bought a kit for the side reflectors, backup lights and taillights 20%. I can't wait to put them on and send pictures!

[RJNavarrete]

Do Headlight Armor products come with any sort of warranty?

[AKAviking14]

Do the covers have an adhesive backing to them like tape does? or are there just strips on 3M tape on the back?

[ChadG]

The vinyl has a layer of adhesive on the back that allows you to stick it directly onto the lens.

[AKAviking14]

Okay great! This will look much nicer on my car than the other covers I have.

[HeadlightArmor]

For our Canadian Customers, due to the postal strike in Canada we are not currently able to ship or mail anything into Canada. We had a couple of orders over the weekend going to Canada and they are currently on hold until the strike is over. Once the strike is over we will again be able to ship and mail to Canadian addresses.

Sorry for any inconvenience.

[HeadlightArmor]

Originally Posted by AKAviking14

Just bought a kit for the side reflectors, backup lights and taillights 20%. I can't wait to put them on and send pictures!

They are on their way!

Originally Posted by RJNavarrete

Do Headlight Armor products come with any sort of warranty?

We do not offer a warranty as how they are installed and cared for is going to be a major factor on how long they last. The material has a normal life of 4-7 years depending on care and geographic location.

Originally Posted by AKAviking14

Okay great! This will look much nicer on my car than the other covers I have.

[AKAviking14]

Thank you sir!

[htp autoworks]

Originally Posted by ChadG

Here is the best picture which illustrates how the vinyl is starting to separate from the headlight (you can see three small bubbles spaced along the upper right hand side of the headlight in this picture). Do you think it is going to get worse? Is there something I can do to fix it?

You know from looking at those I cant tell if there are three bubbles there or if you might have installed the film a little high over the edge of the light. If you can reach up there and feel the edge pulling back there is nothing you can do for them. If you dont then they are bubbles and all you need to do is take a little needle and pierce one side and push down from the other. Sometimes you will get air under the material and it will leave a bubble there. Easy fix if it is. If not it should not get any worse...

[rykeith]

Any good pics of a black camaro with HID Headlight Armor on headlights and foglights? Scanned the thread and couldn't find one.

[HeadlightArmor]

Headlight Armor HID Blue Headlights & Signals Protection
(Can't tell from the photo is the car is black or navy blue - car was too shiny )



Headlight Armor HID Blue Fog Light Protection

[rykeith]

Thank you... wow that was fast. I already have your guy's light smoke on my reverse lights, tail lights, side markers, and turn signals- great stuff.

[HeadlightArmor]

Happy 4th of July Holiday Weekend to one and all!
Our offices are closed today July 1st through July 4th. All long weekend orders will ship beginning July 5th in the order in which they are received.

From now through 11:59 PM CDT all lighting protection kits and smoked taillight kits are discounted a further 15% off! - Automatically, no secret code necessary!

Have a great 4th of July!

[HeadlightArmor]

Our offices will be closed for two weeks beginning July 11th and returning on the 25th. All orders in process will ship before we close. All orders accepted now through the 24th will be produced and shipped starting on the 25th in the order in which they were received.

From now till we return we are offing free domestic shipping on all orders over $20.

Thanks for your support and understanding!

[HeadlightArmor]

Welcome to August! We had a busy last week of July getting all the orderes processed and shipped from when we were closed. All orders taken while we were closed shipped last week, even got last weeks orders done by Saturday! Lots of long days for sure. Thanks again for the orders and your patiene while we worked though the backlog!

[HeadlightArmor]

Holiday shipping notice: As a reminder, we will be closed on Monday in observance of the Labor day holiday, as will USPS for deliveries of already placed orders. Orders placed by 2PM CDT will go out today, all other orders will begin shipping on Tuesday in the order in which they were received. Have a great holiday weekend!

[Harley1]

Sorry wrong thread ....

[laserjim]

Can you see your brake lights good in the day time with the smoke cover? Thanks

[HeadlightArmor]

Yes the brake lights still work during the day.

Standard 30% Smoke Taillight Kit


Stock VS 50% Light Smoked Taillight Kit - Brake Lights


Night smoked taillight testing photos are on the site here

[WildOne]

Do you sell in packages with different tint levels? I want to do all my lenses but want stealth smoke on some and lighter on others. I noticed you do the headlight and fogs in a package that comes out less than buying separately. Thanks!