Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Other Generations > 4th Generation Camaros


Reply
 
Thread Tools
Old 10-06-2008, 04:18 PM   #1
DOOREV800
 
DOOREV800's Avatar
 
Drives: 2010 Camaro SS LS3
Join Date: Dec 2007
Location: Manitoba,Canada
Posts: 18
keyless entry programming

I have a 95 Camaro and want to program another key fob. Anyone know the procedure?
DOOREV800 is offline   Reply With Quote
Old 10-06-2008, 04:25 PM   #2
CamaroScotty
Account Suspended
 
Drives: Your new SLP Camaro!
Join Date: Jul 2008
Location: Cedarburg, WI
Posts: 6,801
Send a message via Yahoo to CamaroScotty
I don't have the 1995 - this is for a 1996, you could try it...

1. Turn the ignition switch to the OFF position.





2. Remove the RADIO fuse.





3. Cycle the ignition switch from the OFF position to the RUN position (as far as you can go without cranking the engine) 3 times within 5 second ending in the RUN position. The vehicle will verify entry into the programming mode by locking then unlocking the door locks.





4. Press and hold both the LOCK and UNLOCK buttons on the first transmitter for approximately 15 seconds. The vehicle will verify programming by locking then unlocking the door locks. Your new remote has been accepted and all existing remote codes have been erased.





5. Repeat the previous step for each additional transmitter (including any existing transmitters). You may program up to 4 transmitters. This must be done before the RADIO fuse is reinstalled.





6. Place the ignition switch in the OFF position. IMPORTANT: The remote keyless entry system will not be operational if the radio fuse is open.





7. Replace the RADIO fuse. If at any time it is necessary to restart the procedure, turn the ignition OFF and proceed again with step number 1.
CamaroScotty is offline   Reply With Quote
Old 10-07-2008, 08:09 AM   #3
DOOREV800
 
DOOREV800's Avatar
 
Drives: 2010 Camaro SS LS3
Join Date: Dec 2007
Location: Manitoba,Canada
Posts: 18
Cool, I will try it tonight. Thanks Scotty!
DOOREV800 is offline   Reply With Quote
Old 10-07-2008, 09:36 AM   #4
radz28
Petro-sexual
 
radz28's Avatar
 
Drives: Ultra-Grin
Join Date: Oct 2006
Location: Crapramento, Crapifornia
Posts: 13,057
WOW! Good man!!! Scotty can even be your Service Advisor
__________________
05 Hummer H2 SUV on OEM Air Ride
Forged 11.1:1 408 LQ4 (K1 crank & rods; Mahle pistons)/CPP LS3 CNC heads/BTR Stage IV LS3 cam and valvetrain/home ported L92 intake manifold/ported 90mm TB/custom Volant CAI/mid-length headers/AFE dual 3" CB/Corvette Servo/el cheapo lift/Cognito UCAs/e'fan conversion/aluminum radiator/Moroso catchcan/HPTuners by me/LED exterior lighting/Pioneer AVH-5600BHS/Pioneer GM-9601/2-Pioneer TS-W310D4/Obcon Labyrinth dual-12 box/lots of other stuff
radz28 is offline   Reply With Quote
Old 10-07-2008, 11:07 AM   #5
Mr. Wyndham
I used to be Dragoneye...
 
Mr. Wyndham's Avatar
 
Drives: 2014 1LE...Drove: 2012 ZL1
Join Date: Jan 2007
Location: Buffalo, NY
Posts: 28,002
Send a message via AIM to Mr. Wyndham
'95 and earlier are OBDI computer-systems. Any techniques used on 1996 to present vehicles probably won't work, because the newer OBDII system was instated -- so be careful. But I suppose it's worth a shot since you're on that borderline...
__________________
"Keep the faith." - - Read Twice Before You Post.
...Anxiously waiting to order a silver "Z"...

Mr. Wyndham is offline   Reply With Quote
Old 10-07-2008, 11:41 AM   #6
CamaroScotty
Account Suspended
 
Drives: Your new SLP Camaro!
Join Date: Jul 2008
Location: Cedarburg, WI
Posts: 6,801
Send a message via Yahoo to CamaroScotty
yep...my sources only go back to 1996.....but I furgured it was worthwhile...I'll dig a little more...
CamaroScotty is offline   Reply With Quote
Old 10-07-2008, 11:46 AM   #7
yotaman96


 
yotaman96's Avatar
 
Drives: 2010 Camaro SS, 2000 Trans Am WS6
Join Date: Jul 2008
Location: Portland, TN
Posts: 2,701
http://shbox.com/1/4th_gen_tech2.html#1995keyless
yotaman96 is offline   Reply With Quote
Old 10-08-2008, 07:54 PM   #8
DOOREV800
 
DOOREV800's Avatar
 
Drives: 2010 Camaro SS LS3
Join Date: Dec 2007
Location: Manitoba,Canada
Posts: 18
yup does not work just for the record. going to try yotaman96 advise. i'll keep ya posted..
DOOREV800 is offline   Reply With Quote
Old 10-08-2008, 08:06 PM   #9
DOOREV800
 
DOOREV800's Avatar
 
Drives: 2010 Camaro SS LS3
Join Date: Dec 2007
Location: Manitoba,Canada
Posts: 18
ok that link did the trick. You just have to jumper #8 and #4 terminals at the dlc. Thanks people!
DOOREV800 is offline   Reply With Quote
Old 10-08-2008, 10:24 PM   #10
yotaman96


 
yotaman96's Avatar
 
Drives: 2010 Camaro SS, 2000 Trans Am WS6
Join Date: Jul 2008
Location: Portland, TN
Posts: 2,701
Quote:
Originally Posted by DOOREV800 View Post
ok that link did the trick. You just have to jumper #8 and #4 terminals at the dlc. Thanks people!
No problem. That site has lots of info for your car.
yotaman96 is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
LOL, a whole Wikipedia entry on Rice-burners Mr. Wyndham General Automotive + Other Cars Discussion 8 12-02-2007 09:36 AM


All times are GMT -5. The time now is 01:46 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2016, vBulletin Solutions, Inc.