- stock DS rating
- Fuel Mileage Improvement with CAI intake.
- NPP Exhaust clip on SS or 1LE?
- Do I need high a ZDDP oil for a cammed engine?
- **Lethal Racing "Night Fury" Cam at it again** Results and Vid Inside
- RX catch can drivers side vs passengers side?
- MTI cam?
- ram air set up
- My 2010 L99-LS3 conversion
- Pypes Cat back rattling on the rear ultra thin cross member
- Mounting 02 sensor for wide band
- Check Engine Light after header install: Coolant System???
- new car build post
- need help asap :(
- NoWeeds
- New Heads & Cam - 485RWHP w/ VIDS!!!
- runs rough at first
- Is it worth the reset if all you can get is 91 octane?
- 2010 Camaro SS HELP
- 93 Octane in Oklahoma!
- lg g5x3 vs lg g6x3
- roller rockers 1.9
- how much horsepower can you gain from a exhaust system and a cai??
- Stainless Works Headers fitment
- Cam
- Afm/DoD delete kits
- Will this work?
- Tunnel brace
- Cam and Headers on daily driver?
- What does the fuse pull actually do?
- Halltech intake disappointment
- Sounds Righteous - Corsa and CAI Cold Air
- Throttle body question?
- Could I ?
- cam sensor ??
- difference between HPE 600 and HPE 650
- Wheel hop?
- Dyno'd yesterday
- NEW MOD!!
- Upcoming N/A Build
- Plugs and Wires
- camora cor
- Borla catback drone?
- Vendors: CAI Inc with IOM accents?
- Help ***Where to buy Oxygen Sensor Extenders ?
- Looking for the best CAI
- 600+rwhp N/A through a 4L80e. Done and done
- Airaid or cai
- LS3 Intake Manifold Gaskets?
- Bluish/white smoke on cold start
- Who has 3" kooks exhaust?
- Exhaust gasket material
- Header Bolts TOO Tight ?
- Performance Exhaust Upgrade Package 92231570
- Redline Water Wetter
- Video of how my car sounds before & after!
- Tune? With long tubes
- Measured pushrod length: stuck between two sizes
- Installed ported TB and cold air intake
- Who has best deal on ceramic lt headers and cats??
- Need help picking a Cam
- Let me know what you think about my cam choice
- Header?
- What would you do?
- Feedback please :)
- Downside to LT Headers?
- California emissions
- Totally impressed~!
- What Mods (If Any) Do You Regret?
- mods are being installed
- K&N typhoon inlet tube?
- I wanna do it my self!!
- Advice on spark plug heat ranges for cammed engine
- Lifters replacement
- Need help: any videos of sw retro and lt headers and maybe cam'd?
- Dealership/ mods/Warranty question
- Headers ???
- WTB Axlebacks
- Texas Speed 304 Polished Stainless Exhaust Back In Stock!!
- L99 converted to LS3 converted to N/A
- stainless power headers
- Just got my Vmax Tb but have?
- Headers Installed and JRE Tune Uploaded....
- Air circulation in the 'stock' engine bay.
- V8 engine cover for FREE
- RX CC not working now?
- Exhaust help needed! LOUDDDD!
- Blower Cam Idle
- jba catback question
- RPMs Jumping a lot - Help!!
- Need help with my future L99?
- Tips for open headers
- L99 Tune or headers first?
- Other parts that should be swapped during cam install?
- Exhaust or hf cats
- Underdrive Pulley...Worth It??
- L99 lifter question
- Solo catback muffler on v8
- Best method for gutting cats?
- G6X3 Cam Questions
- 1st performance mod ordered
- Oil Pump Install Help
- whats next?
- New ERA intake + FAST 102/102
- 2010 Camaro 1SS LS3 M6 won't spin tires
- Shop did not install my C5R chain and LS7 dampner during LS3 conversion
- Will this make the AFM drone worse?
- New to the Camaro. intro and question
- About to place order. Anything missing?
- JANNETTY RACING MAKES THE VORTECH BLOG AGAIN!
- Nick Williams or FAST throttle body?
- Question on Intake's
- Will the L99 Stock exhaust fit on LS3?
- Deleting rear cats, will it throw a code?
- OEM Air Box
- Lets tighten those bolts
- Underdrive pulley damper and stock timing chain / tensioner issues
- Why do very few start with rear gears?
- Looking to swap out Flowmaster mufflers for?
- Exhaust Help
- How much for Muffler deleted?
- Night Fury Cam by lethal racing, thoughts?
- magnaflow #15090 catback competition exhaust
- Dyno max bullet mufflers added
- Chasing possible Vacuum Leak ? LTFT's +20 at Idle
- 500-520 HP N/A what is needed?
- So I know I need a tune but do I need a custom tune?
- New exhaust
- Texas Speed AFM-2 L99 Cam
- Need shop to do a L99 to LS3 Conversion
- Hitting the rev limiter in S Mode?
- Question about ADM P.I.M
- Cold air intakes for the SS
- Questions about installing a cam in an l99
- Lifter tick in supercharged / cammed ls3?
- Where is your oil pressure at? (Cammed)
- tuned ls3 with supporting mods
- Really? That's it?
- headers and high flow cats
- Rough idle and low rpm idle
- JRE 470 package toughts ?
- Installed a C.A.I. Intake This Weekend
- SLP Loudmouth II axle back
- Single bolt vs 3 bolt cam
- Cam and Gears?
- Lingenfelter
- Good Dyno Numbers??? How to pick up more HP?
- Flowmaster Outlaw Exhaust 2012 Camaro - For sale
- New to the performance world need advice and tips.
- Muffler delete
- Dual Optima Batteries Installed
- Maximizing power with stock H/C and N/A...?
- exhaust back pressure question
- BBK Longtube Headers
- LT Headers questions
- Suncoast ZL1 heat extractor hood?
- JBA HighFlow CATS or Solo High Flow CATs?
- difference for the LT headers in 1 7/8 or 1 3/4
- Breather Caps
- Good/Reputable shop on Oklahoma?
- question about cutouts
- Cam,LT Headers, custom tune
- Oil Catch Can
- Side vented exhaust question
- Next Mod
- Any feedback in the ADM ported intake Manifold?
- Trunion Upgrade Questions
- Installed CAI, Scoop, Washer Bottle - All from Apex
- 160 Thermostat
- Throttle body?
- gains after tune?
- cam cam quesstion!!
- exhaust price
- Thank you all at Jannetty Performance
- vararam ??
- Sponsors or forged motor guys
- CAI and RX Catch can Installed. Thanks JDP
- Bent Stock Toe Rod in an Auto!!!
- Exhaust
- A.R.H./Farks Supercars Facebook Page
- Next Mod?
- Rubber seal on CAI?
- 427 and your mpg
- Adding Solo J pipes to SW Retro Chambered 3"
- Quality Cam Install within one days drive time of Oklahoma City??
- Roger's 2011 JRE Tuned SS LS3 M6
- Polished ceramic or 304 stainless headers?
- Question for yall
- LG Motorsports complete exhuast
- First Mod Muffler Delete
- thinking about Dynamaxx
- Flowmaster AT installed!
- Solo cat back not happy?
- Installed my Lingenfelter/Corsa Axle Back
- water pump
- What will happen???
- Comp Cam info
- My New Cam Video
- Cam + Headers + HF Cats + 3"Catback: Will resonated X-Pipe reduce drone?
- Whats the Best C.A.I for a maggie
- Factory Resonator Delete?
- Recipe for power
- Unplug negative battery cable when installing a CAI?
- Can't spin the tires loose on my '12 SS...
- Good Morning f/ North Ala, New member question,
- Header install with 10" ramps
- what's the best "cat back" exhaust for a ls3?
- Borla S type Exhaust Rattle
- I wanna boost, I dont wanna bomb
- JBA Catted Midpipes throw a CEL?
- Throttle body
- JRE or Lethal Racing cam?
- Headers!!!
- KOOKS or AMERICAN RACING
- Just ordered Cold Air Iductions inake, race scoop an washer relocation kit
- 2010 2SS V8 exhaust
- HOW long does it take to swap out oil pumps
- exhaust
- Free Catback Install on Stainless Works for the month of July
- Wtb a Borla S Type. Cat back
- Hp tuners map help
- Cam going in Friday!!!
- Just got JBA Headers/Cats and 3.91s installed!
- Just got my car tuned
- I'm over my head with headers.
- where is the oil pressure sensor??
- OIL pressure at hot idle
- Nervous Nellie - questions...
- Mrt for v8.
- just another noob header question
- Not trying to be "that guy"
- Singing The Praises Of K&N!
- UNDER ENGINE COVER?
- Cam/Header Upgrade!
- Anyone do LT with stock midsection and axleback?
- 2011 A6 resonator measurements
- Fuel Feed Line
- VIN on Engine Block
- Catback or not???
- Let's make some sense out of SCT datalog......
- Who's cam makes the most power?
- Valve Cover Gasket
- Dynatech
- Your Thoughts!!!??!?!?!?
- harmonic balancer doo dad
- To Weld or not to Weld?
- ? about GM "Off Road Exhaust"
- Looking for Best Bolt on power with out that nasty CAM. HELP:)
- TSP CAM, Replace Springs and Pushrods?
- Guys with cams