Hey there,

Sorry, I just saw your message.

I went to Life's Good Racing in Livermore. They are a race shop and are amazing to work with.

It was expensive, I think 8 hours labor, however there were 2 factors that played into that.

1.) I was one of the first to have it done in a gen 6 Camaro , so there was no references out there. There are quite a few tricks out there now.

2.) I asked them to not use a torch to heat up the cradle to get the rubber bushings out , so instead they had to jig saw them out in pieces, that added a lot of time.

They are an excellent shop. I have my exhaust done there too and 2 years later, then still have my stock system hanging on a rack in case I ever want it back.

If you go there , Ask for Chris and tell them Donovan sent you.

Hey Man,
Looks like you are from Bay area, where did you go for the solid rear subframe bush install ? may I ask you how much they charged ?
Looks like a real PITA to DIY
Cheers