LSU/LS3

I would run 25lb on the street and 18 at the track to keep the centers from wearing first. 32lb is what I ran on street before.

I will give you a call tomorrow

Do you want to look at them first? I don't want to pull them off the rims unless they are sold. I live off of Coursey Blvd. and Sherwood Forest. Call me on my cell 938-7908. I can pull them tomorrow but I want to be sure you are buying.

Ok I will take them. Is there a way I can get them this week?

The Nitto drag radials 275/40/20 have a little less than 1/2 wear left. The tire wear indicator has just been reached but still has a curve in it. They come with 6/32 tread and now have a little less than 3/32 tread. They are worn the most in the middle and would not be good on wet roads but still good for the track and dry roads. The tread in the middle is less than 2/32. 35 lbs of air was too much for the street.

Someone else has asked about them and I told them I needed to check with you first. I would need $300.00 which is half of what I paid for them. They have about 5,000 miles and 40 passes on them. I also need to take them off of my rims.

Sorry they are sold. I posted a video of my 11.94 run at SCR with reference to You Tube at http://www.camaro5.com/forums/showth...t=31174&page=4

You might want to keep checking the thread, I need some tips for getting a good run down the track, I am continue to add tips almost daily.

It was nice meeting you at No Prob as well. I forgot about the Superbowl on Sunday. Still if the weather is nice it won't be crowded.
The thread I meant to refer you to was "I need tips".

Probably go to SCR Sunday next. Need 50 to 55 degree surface temp to get good hook. Check out my comments under drag strip section "I need help" for some good tips.

Sorry I haven't been back to you. I have dynorun photos in my photot album on my home page for my mods. Mods are listed in my garage.

I just installed SSR 17x9 and 18x8 16lb. rims and 295/45/17 MT DR's. Going to State Capitla tomorrow, Sunday, hoping for mid 11's.

What kind of headers did you go with? I was getting the Dynatech but he said he has ARH in stock