Quote:
|
"We are sorry. You added a supercharger. Your seat knob is not covered."
:laugh: Sorry....lol. I'm sure they will get you taken care of, no problem. I just had a bunch done too. If you find something that you know is on "the list" of TSB bulletin problems, you might want to print it up for them as you bring it in. My guys looked right over the two problems I brought mine in for and I had to point them out on the list for them to get taken care of. |
Quote:
.... nevermind :bellyroll: |
Quote:
Ummm... NO !!! Maybe the glass...:D Hey GTA - Did they fix your THR22? |
Quote:
:laugh: http://www.camaro5.com/forums/pictur...ictureid=30002 :iono: Quote:
:D |
I get to take mine back in Monday. If you have any issues that deal with TSB stuff, might wanna print up and take that with you. I had to show them to get them to understand what my issues were (brakes squeaking up front and the back panel by the speaker vibrating). They are going to get them changed out and fixed Monday.
|
4 Attachment(s)
Finally swapped out the mufflers...
the 2.5" are on there now... Much louder than the 3" chambered I had on there... A LOT louder. Sounds Nasty. but I'm thinking it may be too loud. Now, I've got an exhaust rattle I need to chase down... But it was fun.. :D the kiddos came out to give me a hand. |
Apprentice mechanic's are always good.
:thumbsup: |
Awhaha!! That's so cool!
(I see you've replaced that 'towel rack' for something a little more useful? ;)) |
nice! yeah, that smaller piping should help bring the exhaust gas velocity up a little being there at the end of the system like that.
i can't wait for some audio clips! |
Quote:
Quote:
but... I don't remember it... :laugh: Quote:
|
Sweet! Can't wait to hear it. :popcorn:
|
exhaust rattle...
go to home depot talking one of the tunnel brace bolts with you and get some spacers. I put 3 spacers on each bolt (4 bolts total needing 12 spacers) and that lowered the tunnel brace low enough that I don't get that d@mn rattle anymore. Talk about a pain in the rear, man. That rattle drove me nuts. Just drop that tunnel brace and put it back in place with those spacers. It will lower it about a quarter of an inch and that's all that you need to prevent the hitting of the exhaust pipe to the tunnel brace. Cost? $2.30 (vs buying a new special tunnel brace for $100.00)....even thought that new tunnel brace looks cool as sh!t....lol |
Quote:
See this thread... http://www.camaro5.com/forums/showthread.php?t=105015 I must have one of the clamps a little loose, this rattle appeared after the muffler swap. |
All times are GMT -5. The time now is 01:39 AM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.