Getting cammed!
 

I pulled the trigger and bought mace cams...my question is can I take it to a shop get them installed and limp it home without a tune? At least until I can get will at will overkill to tune it remotely. I just don't wanna do any damage to my engine....thanks for any input

You can drive it home without a tune, it may just start rough and be sluggish leaving idle.

Thanks magnumforce, I figured just wanted a second opinion

I'm super curious what will be your impressions. Do you have any other mods?

I advise to dyno the cat before and after on the same dyno.

I'll be doing the some with few extra mods around May.

Sent from my SM-G965F using Tapatalk

Ya I have a cold air intake, 2015 Colorado manifold, 80mm throttle body, will overkill tune, high flow exhaust, and high stall torque converter... also a jacfab spacer... nitrous have yet to install as well as meth injection...i haven't dynoed I go by my 1/8th mile times

They aren't much bigger cams than stock it will run fine. Whereas the LS3 etc performance cams makes them sound like a tractor and they run rough without a tune. So dont expect huge gains.