Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com

Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com (https://www.camaro5.com/forums/index.php)
-   Camaro V6 LFX Engine, Exhaust, and Bolt-Ons (https://www.camaro5.com/forums/forumdisplay.php?f=148)
-   -   MRT V1 Installation (https://www.camaro5.com/forums/showthread.php?t=255122)

colingordon 10-12-2012 09:14 AM

MRT V1 Installation
 
Hey guys I am getting my MRT V1 today and gonna install is most likely tonight.... Any tips? And how far did you cut after the muffle?

Juiced1 10-19-2012 08:16 AM

The measurements are in the instructions. Jack up the back end nice and high to give your self some room. Mark the cutting point with a marker and place some masking or painters tape on each side of the mark. That way you have an easy target to cut. Slip the new cans on and hand tighten the clamps. Make sure your tips are lined up right (helps if you have a second set of hands) and finish clamping them down. Start er up and enjoy!

Jbakovich 05-10-2013 10:45 AM

You say "clamps" where do you get them? are they with the exhaust?


All times are GMT -5. The time now is 08:19 PM.

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.