BMR End-Links and Toe Rods Installed
 

I did the install at my house this weekend and it was fun. The only part that sucked was having to drop the rear cradle to install the driver side toe rod... other than that it was cake!

Here are some pics

Attachment 207325

Attachment 207326

Attachment 207327

Attachment 207328

Attachment 207329

Attachment 207330

Those end links are just a little bit beefier than stock, huh? :laugh:

just a little!! :D

Nice install pictures! Looks like everything went in pretty easy. :D

It went well! Oh and Kyle i think i had you on the phone today about the sub frame brace and bushing kit and my phone dropped the call!! my bad i was walking into my next class and couldn't phone back!

Somebody has the bug! :headbang:

haha yeah! I cant stop!

ok so what method did you use for droping rear subframe? I am about to do toe rods and inserts!

motorcycle jack is what i used.

Great pics, thanks for sharing!

i had 4* jack stands and a jack... that did the trick! its not to bad.

Two jack stands under the front cradle and two more under the rear subframe just in front of the rear cradle. These will hold the car up and keep it stable while you lower the rear cradle. Most just use a floor jack under the rear cradle, remove the 4 bolts then lower the cradle with the jack...

I plan to put race ramps on front and jack stands in the back. When you say just take out the 4 bolts and lower with jack where is the jack positioned to keep the cradle from rocking or falling?

You can safely support the cradle with the jack under the differential. If you don't have a polyurethane pad on your jack, make sure you put a piece of plywood between it and the aluminum diff housing. you will have to play around with finding the balance center of the assembly but it's not too bad one you find it...