new floor jack
Got question for u smart ones... is a 2ton low profile with a minimum of 2-5/8" gonna be able to fit under camaro with no gfx and 1.4 lowering springs.. thanks guys
|
I have a low profile jack and have problems getting under the nose. Mine isn`t even lowered.
|
Quote:
|
Quote:
|
it should work even with the springs. I have one and it is tight, but will fit.
Worst case you'll just need a coule of 2x12 boards to drive the front up on so the jack slides under like we do for lowered vettes |
Thanks everyone!!! Boards are a perfect idea.. wat kinda ramps you using
|
Quote:
http://www.discountramps.com/car-repair-ramps.htm |
Tryhttp://www.raceramps.com/ raceramps. Also,pricey but alot of different options. Cheapest and works fine are 2x12's though!
|
I have the Tirerack low profile jack and it works great, but I still want a set of ramps to go with it.
|
Was just ready to buy a low profile jack. Thought too much into it, 2x12's such a money saver. Great idea! Too much tought sometimes is a bad thing.
|
You might want to go larger than a 2 T jack though.
|
Quote:
Also, I usually drive up on four blocks of 2 X 12's cut 12 inches long (one under each wheel) which raises the car 1.5 inches. |
Arcan XL35 Jack is the one I use. Low profile with a 28" lift height. Goes under my lowered Supra fine and its like 2" off the ground lol.
|
All times are GMT -5. The time now is 10:25 AM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.