2014 Yellow 2SS - Build Thread
 

Base Car
2014 Camaro 2SS
Yellow with black factory stripes


Audio / Electronic Mods [https://www.camaro5.com/forums/showthread.php?t=526362]
Infinity Kappa 4 amp driving Morel Tempo 602s and Infinity Perfects
Zapco ST-1000XMII driving a Sundown SA-10 R3 Subwoofer
Approximately $2,000 total...plus $1300 to repair the hydraulic line I drilled a hole through; ho-hum...


Exterior Aesthetic Mods
$2000 (minus $800 from selling OEM hood) - VIS Racing Terminator GT carbon fiber hood (plus custom paint).
$2000 VDI vertical door mod
$1000 - Halo reverse tilt hood kit (and install)
$850 - Painted Razzi ground effects kit purchased from Phastek [ https://www.phastekperformance.com/2...o-430-100r.htm ]
$99 - Z28-style spoiler purchased from Spoiler and Wing King on Amazon [ https://smile.amazon.com/gp/product/...?ie=UTF8&psc=1 ]
$200 - Painted engine compartment components
$20 - Stripes extended down back via black plasti-dip + glossifier


Interior Aesthetic Mods
None yet...


Performance Mods
None yet...
(My last car was a Tesla and very fast, and I'm getting older and don't hot-rod as much; it's hard for me to focus too much on performance)


Todo List
$1200 (minus selling OEM) - Carbon fiber front fenders.
$100 - Paint center console yellow to match car

https://i.ibb.co/xG012Yx/20210907-100807.jpg

https://i.ibb.co/jfNws6W/20210906-141008-2.jpg

https://i.ibb.co/qn7mZtg/Webp-net-resizeimage.jpg

https://i.ibb.co/xjbz6Df/1.jpg

Very nice!!!

Subscribed, nice car!!

I just looked at the kit and the demo for installation and I was surprised to see it the front chin in glued on... I'm not sure if I like that. Is that what you did?


joe...

Thanks for the compliments, all. :)


Yes, that gave me pause as well. I contacted Razzi and they send the glue with the kit and that it can be removed with some kind of chemical. I never planned on removing the ground effects so it didn't matter much to me, but I did like knowing that the option was available.

Added a few new pics of my new hood, vertical door mod, and paint practice area (aka: engine compartment). :)

I also wanted to say that if anyone going with the Razzi ground effects, avoid using the glue they provide. Getting it off proved just about impossible. Instead I invested in some xps blocks cut to fit perfectly between the bottom of the front bumper and the ground effects. This creates enough pressure to prevent the lip from lifting, which seems to be the only purpose to the glue anyway.