562 HP 2010 Camaro SS Supercharged Dyno Test
 

:confused0068:

http://www.youtube.com/watch?v=8jWQ0kBJYzQ

Love it... more please! :p

Hope they aren't too fond of their connecting rods!

I think from the other post on this .. that is estimated CRANK HP not RWHP ... I'm a little dissapointed .. however I hear that isn't the final tune so stay posted ..

Crowley

Connecting rods aint the #1 problem homeboy... its hypereutectic pistons, 10.7:1 compression and forced induction.... Hope they have an intercooler, water injection and a really good PCV system!

Haha, gee that sure looks like the car Magnuson was installing a TVS 2300.

Could that video be of the Magnuson car?

http://www.camaro5.com/forums/showth...agnuson&page=2

Look at the link in post # 33

It's the same video.

I am very interested to see how this turns out.

I had a TVS 2300 on a stock LS3 on the dyno several months ago.

It made a ton of torque at 3700, so much so I got cold feet because I was afraid I was going to hurt the engine.

It made 728 foot pounds at 3700 RPM at the crank.
It was at 556 horsepower by 4000 RPM where I cut the test short.

Waiting to see if they turn down the boost to keep it alive.
The TVS 2300 is a bad bad blower......

Robin

I think they were saying they were keeping the boost at around 6 lbs. I think we're going to get more results very soon after they're done tuning.

That sounds pretty sick, what blower are they using?

:drool:

Love it! Sounds freaking awesome.

GT500 is going to be Terminated.

Until the gt500 buys a 60 dollar pulley :sm0:

:cry: