Automatic transmission shifter assembly removal
 

As I was installing a new Alpine in my 2013 ZL1, I broke off the plastic, spring loaded mechanism that is attached to the shifter stem and covered by the shifter knob. After extensive web searching for the plastic piece, all I could locate was the whole shifter assembly (part #22894722) which houses the plastic mechanism. Has anyone repaced this assembly and if so, can it be done through the console without going underneath the car? Also, not sure how to remove the assembly as there are 4 pins without a hexhead securing the assembly to the transmission.
Much thanks for any help! I have to think this must have happened to other folks

Probably very little help for you here, as this is the Z/28 section and none of them are automatics.

Yikes! Thanks for the info. Will move this to another forum. Thought this was for ZL1s too.

Try the ZL1 section, chances are someone there can help! :happy0180:

What's this "automatic" thing you speak of?

Its a 2014 with that a shop replaced the M6 for an auto trans.

Yes what is this?

Think I have seen one of them. Has a mystery donut filled with red jelly in front of it????