QTP cutout piping kit
 

I have the piping kit with the cutouts mounting points that QTP sells on their website. I moved my cutout to the rear of the car and no longer need these. They are bolt on and work very well. I have pictures I can post later but I have included the manufacturer picture, does not come wit the cutouts.


When I ordered them I paid over $500 with shipping. I'm listing these for $300 and can entertain shipping them. If you are interested shoot me an offer.

Hi,
Do you have the clamps for both ends and the switch?
Shipping would be to 11716
Thanks, Pete

It only came with the clamps shown in the picture. I do have a switch but I am using it on my system, you can order them from QTP's website.

What diameter are these? Can you post pictures of the actual pipes? Is there a particular reason why you are relocating them?

The pipes are 2 1/2 in diameter. They slip on over the factory piping, you just have to cut the mid pipe section, just after where they make the 90 degree turn going to the back of the car. The quality of this kit is very good, nice welds, good fitment. I had always wanted to have my cutouts in the rear of the car, I have no complaints about how they were in the front however. I just finally was able to find a way to put mine in the back that's all.



Sorry for the delay in my response, I have been busy at work this week and not had much time to get on here.

BUMP

Price drop to $200 buyer pay shipping