Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com

Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com (https://www.camaro5.com/forums/index.php)
-   Member Car Journals (https://www.camaro5.com/forums/forumdisplay.php?f=50)
-   -   Pyr0b0y's SS Build Thread [COTW 5/23/11] (https://www.camaro5.com/forums/showthread.php?t=130720)

pyr0b0y 02-21-2011 01:43 PM

TRON Camaro Build Thread [COTW 5/23/11]
 

TRON Camaro:
Team Turbo Legacy Facebook Page
TRON Camaro vs. Bugatti Veyron SS
Vinyl Wrap - 722
HDR Photoshoot - 725
Early Drawings - 801
GTA IV TRON Render (not done by me) - 797

Articles:
LSXtv ZL1 Front Bumper
LSXtv TRON Camaro
Guy Speed
Giant Freaking Robot
Complex Rides
Obvious Winner
HiConsumption
Crnchy
Socialeyezer
Crank and Piston

Media:
Take-off with supercharger and longtubes - 87
Supercharger idle and flyby - 97
Supercharger Dyno Tunes - 139, 142
AutoX at CFII - 175
Twin Turbo First Startup - 402, 408, 438
Twin Turob Dyno - 583
Car Shows - 647, 655, 668
Time for a Tow! - 412, 429

Dynos:
Supercharged Dyno Results
Twin Turbo Dyno Video

Motorsports:
AutoX - 600, 601
Track Days - 609, 611, 612

Performance Mods:
Carbon Fiber Intake - 712, 718, 720, 735, 749, 798
418 Stroker - 320, 291, 354, 370, 802
Twin Turbos - 370, 376, 389, 401, 442
Greddy Electronic Boost Controller - 344
Exedy Twin Disc Clutch - 376
VMax Ported Throttle Body
Hurst Short Shifter
AEM Methanol Injection
DSS Axles and Driveshaft - 400
Aeromotive Fuel System - 401, 442
Aeromotive Speed Pump Controller
Hawk HPS Pads
Stoptech Steel Braided Brakelines
Slotted and Cross Drilled Rotors
Accusump - 489
Oil Cooler - 492
Blu808 Roll Cage - 288
Rear Seat Delete
Sparco Evo Seats and 6-point harnesses - 551, 555
Engine Bay - 703
Fuel Lines - 758

Cosmetic Mods:
ZR1 Custom Carbon Fiber Hood - 511, 637, 645
Seibon Carbon Fiber Trunk - 645
Custom Carbon Fiber A-Pillars - 369
Custom Carbon Fiber Mirrors
Custom Carbon Fiber Gas Cap
G3 Composites Carbon Fiber Radiator Shroud
ZL1 Front Bumper - 511, 517, 528, 645
5% tint on back windows, 15% on front driver and passenger windows
ACE Custom Steering Wheel
DSV Customs Speedline Center Console
RGB Halos - 528
RGB ABL Doors - 572
Switchback Blinkers - 2, 264
AAC Concept Sidemarkers
AAC Blue Interior Lighting
PLX Gauges - 389
Custom Closeout Rear Diffuser
Stainless Steel w/ “SS” cutout in yellow carbon fiber door kicks

Rims:
Cruising
360 Forged Concave Mesh Rims - 371, 452, 645, 647
TSW Croft Rims - 108, 179
Track
Forgeline GA3R Rims - 611
Toyo R888 Tires - Front 295/30/19 Rear 315/30/19

Suspension:
BC Coilovers - 163, 179
Pfadt Subframe Bushings - 442
Pfadt Diff Bushings -394
BMR Rear Trailing Arms - 400
BMR Front and Rear Sway Bars
Hotchkis Max Chassis Brace


In-car Entertainment
Alpine Dash kit with a W910 Head Unit
2 x 10" Kicker CVR Subs and Boxes
Kicker 1000w Amp
Backup Camera

Old Setup:
Supercharger and headers arrive - 8
Supercharger and Cam being installed - 19, 37
Supercharged Pictures - 176, 179

Upcoming Mods
Katech Carbon Fiber Valve Covers
Dual HKS SSQV IV Blow Off Valves
Custom Carbon Fiber front brake ducts
Custom Carbon Fiber ZR1 Side Skirts
Custom Carbon Fiber Rear Diffuser
Custom Carbon Fiber ZL1 Lower Bumper
CTS-V Brake Setup
V2 Afterburner Taillights

*Never Fogotten 2001 Z06 Vette* - 121

Well I finally got my Camaro on December 1, 2010 (1 year at my current job!) Like they say, third time's a charm! I originally wanted the camaro when you could first preorder the car back in Nov of 08. I put my $1000 deposit down, but lost my job in February so my dreams went out the door. I tried again in June of 2010, but my credit was not high enough (I was 19 years old). Finally tried on Nov 23rd and got approved! I Took delivery of a Rally Yellow Hardtop with Black Racing Stripes on December 1st. I got a 2SS/RS M6. I had no clue how to drive stick and stalled the car pulling out of the dealership! I spent about an hour in the neighborhood trying to get better. I finally decided to go back to my house, which was NO BUENO! I live in the hills and did not think about rolling back at all the stopsigns.... *oops*!

I had a ton of mods planned for my car already. I had already taken a look at different options for supercharging my car. I decided to get a TVS2300 blower. The next week I wanted to do some blackout accents on my car. Tint happened shortly after that. I added side vent gills; blackout parking lights, blackout rear panel, Bowtie and SS blackout, and wrapped the roof ditch molding in carbon fiber vinyl.
I ordered a RotoFab cold air intake and got that installed; picked up a little horsepwer!
Switched out my license plate lights to white, dome light to blue as well as strip lighting under the dash.
Got my AAC Concept Sidemarkers installed, will be posting pics soon.

pyr0b0y 02-21-2011 01:45 PM

got around to rewiring my blinker lights. I used a 2 tone bulb and tapped into my halo wiring so i have white led's as running lights with halos. You don't really notice it in this pic but the halos are just a slightly different tint. I'm considering swapping them with higher output CCFL rings, but not too excitied about baking my headlights in the oven!

http://i56.tinypic.com/6yil4i.jpg

SSE 4 2SS 02-21-2011 02:22 PM

Great Start, and congrats on finally being able to get the car... I had my own trials in that area...

I'll be following this one...

2010 SSRS 02-21-2011 02:23 PM

looks great

pyr0b0y 02-21-2011 04:18 PM

supercharger should be arriving at my house tonight, will post up pics later of my overdrive cog drive, and jba headers...gunna be an exciting week! :happyanim:

GTAHVIT 02-21-2011 04:31 PM

:headbang:

Now the real fun begins! :thumbsup:

2010rod 02-21-2011 04:55 PM

Cool. Congrats Josh.

pyr0b0y 02-21-2011 07:47 PM

Just got home from work and my supercharger was in the garage!

http://i51.tinypic.com/2zs7if5.jpg

JBA 1 7/8" coated headers

http://i53.tinypic.com/n5mxbq.jpg

JBA Catted Midpipes

http://i53.tinypic.com/a5cf2v.jpg

Comp Cam is already at the shop and rims should be in the next couple days. I will be getting my car dynotuned on Friday; hoping for around 600+hp!!!

Silver2SSRS6spd 02-21-2011 07:59 PM

Congrats and good luck on the dyno. I'm glad the supercharger made it to your place without incident. Your car is going to be bad a$$ when it's done.

pyr0b0y 02-21-2011 08:01 PM

Thanks, glad the supercharger made it! Had my brother pop open the box and double check while the UPS guy was at the door!

M6HuggerSS 02-21-2011 08:09 PM

cant wait to hear some sound clips of that set-up...

what are the specs on that cam?

great looking build btw.

Silver2SSRS6spd 02-21-2011 08:28 PM

Just voted for the T-Tops. Subscribed to this thread. Your ride will be the car of the week when you are all done.

YOUNGnRECKLESS 02-21-2011 08:38 PM

Voted for T-tops as well. Not many out there. Props on the supercharger and all the new performance. Can't wait to hear it when it's all put together.

good luck with it.

pyr0b0y 02-21-2011 09:29 PM

The cam system I got was from LG Motorsports. It's the G6XB system; it includes the Camshaft, Comp 921 Dual Valve Springs, Hardened Push Rods, Titanium Retainers, Seats, Seals and Heavy Duty Timing Chain. Here's the link in case you're interested:

G6XB Cam System

My system isn't on their website, but they have similar systems with specs. It's been tested by LG but their not ready to release it yet (I was assured my car isn't going to blow up!)
It's not street legal but at this point, dont really care anymore!


All times are GMT -5. The time now is 01:01 PM.

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.