ACS T3S ports installed!!! (finished)
Hello C5,
I'm about to tackle the install of these bumper ports on my 2010 RJT. I'm really excited to get started however I was wondering if anybody that has installed them has any tips or tricks for the install. Thank you! Update!!!!! I finished the install, everything went great. I just took my time and measured over and over until I felt good enough to start cutting. http://i1317.photobucket.com/albums/...psghxjaen5.jpg |
So I got started on doing the install. I'm taking my time and I have measured quite a few times. Seems that the ports outline that I will be cutting is symmetrical on both sides which gives me the green light to go ahead and start cutting.
http://i1317.photobucket.com/albums/...pszkykkgxc.jpg http://i1317.photobucket.com/albums/...psgpytoi8v.jpg http://i1317.photobucket.com/albums/...pszqdzspje.jpg http://i1317.photobucket.com/albums/...psouiyte8w.jpg http://i1317.photobucket.com/albums/...psxezwklwy.jpg |
does anybody know which DRL kit would be best? I'm kind of thinking of running the eagle t3. where its three LED pods on the side of each port.
|
That came out amazing! Braver man than me doing those cuts, what did you use to cut?
|
Quote:
|
Nice! That turned out great.
|
Quote:
|
Nice work! Looks good!
|
I like it ...well done!!
|
Quote:
Quote:
|
gorgeous work
|
They should come from the factory like this on the SS
|
Quote:
Quote:
|
All times are GMT -5. The time now is 06:52 AM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.