MyLink faceplate poor fit
2 Attachment(s)
I have a 2011 Camaro and just did the MyLink Nav upgrade. Upon installing the faceplate, I notice I can't get the screen to lock tightly in place and have a gap around mostly the top between the radio and the dash. The fit on the passenger side is worse. Is there something I'm not doing correctly?
|
Quote:
So I have not installed this unit, but I just did an aftermarket radio install using the pac kit. I found that getting everything to fit behind the radio was a challenge. Had I known that the space was so limited, I would have installed a multimedia radio (much more shallow than a regular double din with a CD drive). Do you think you could get some of the wiring back tighter? |
Did you trim the top 2 guides/supports on top of the mylink that were used by the old style radio?
https://www.camaro5.com/forums/showp...5&postcount=57 Also you should have trimmed the rear area also (see where I have blue tape). Had to trim the gauges/pod area to fit correctly... Did you buy Gen5Diy’s kit? -Don |
I have the upper supports and the receiver fits fine. I did trim the back too. Does the bottom go in first (by the 2 bolts) and then swings up to snap in?
|
So spoke with Gen5DIY and had to remove my center console (again) for the faceplate to fit well. Really like this upgrade!
|
you dont have the bottom properly inserted. remove and reinsert and adjust
|
Looks like you fixed it but I had the same issue when I did the install. Eventually I took a break and came back and it popped in.
|
Quote:
|
nice to know the tips on how to fix from the experts and appreciate their efforts
|
All times are GMT -5. The time now is 03:45 PM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.