Elite E2 Catch Can Install Help
 

So i'm so confused...I have an E2 can installed..I have seen and heard and read so many different ways on how the hoses are supposed to go..I even emailed Elite this morning...So if i have it right, the bottom pcv port on the engine is the (outlet) that goes to the top of the can (inlet to can) and the side (outlet of can) goes to the top pcv port (inlet) on the motor ?

That is correct. The vapors go thru the top and get trapped in the wire mesh and etc in the top of the can, builds up then drips down creating the oil puddle at the bottom of the can.

ZL1 KID
 

So my set up i right as far as inlet & outlet from the motor ??

These instructions should help.

http://www.eliteengineeringusa.com/c...structions.pdf

yes, this is how i have mine installed, but another member sent me a video on FB and he has his hoses installed different than this and says his can works fine.....so i was confused....

I can understand, I was super confused before I installed mine because I searched too many threads. You cant go wrong with the install instructions.

KJ,
yeah , I have less than a 1,000 miles on my Zl1 and there is some oil in the can and I have never seen any type of engine code so far...knock on wood !!!

That's how it should be. Good job and enjoy your Z

YOU THA MAN !!!

That is awesome!! Enjoy your oil free intake!