Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Roto-Fab
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.05 seconds. Search: Posts Made By: L78toLT1
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-13-2025, 07:23 PM
Replies: 3
Views: 410
Posted By L78toLT1
I replaced my 2016 3:73 (m6) diff with a unit...

I replaced my 2016 3:73 (m6) diff with a unit from a 2018. The diffs appeared to be identical. I'm reasonably confident that any year gen6 diff will bolt right up. I'm pretty sure the trans will as...
Forum: Camaro Price | Ordering | Tracking | Dealers 10-09-2025, 09:57 AM
Replies: 18
Views: 1,267
Posted By L78toLT1
I'm not looking to sell my car, however, if...

I'm not looking to sell my car, however, if someone wants to give me the full purchase price of the car plus mods, it's all yours!
Forum: ZL1 Discussions 08-17-2025, 05:54 PM
Replies: 23
Views: 2,358
Posted By L78toLT1
Is the simple answer really YES? I've had my...

Is the simple answer really YES? I've had my motor apart more times than I can count, and I don't see how it would be possible. I suppose if you're swapping in another DOD cam, it may be possible to...
Forum: ZL1 Discussions 08-17-2025, 05:38 PM
Replies: 4
Views: 823
Posted By L78toLT1
I replaced a damaged radiator on my magnuson...

I replaced a damaged radiator on my magnuson supercharged SS. I assume that performing this job on am LT4 is very similar. It's been years, and I don't remember all of the details, but i do remember...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-22-2025, 10:21 AM
Replies: 7
Views: 1,182
Posted By L78toLT1
Are you still running the OEM thrust bearing,...

Are you still running the OEM thrust bearing, Josh?
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 06-07-2025, 04:50 PM
Replies: 1
Views: 277
Posted By L78toLT1
I have an LT4 hpfp that I'll let you have for...

I have an LT4 hpfp that I'll let you have for $500 + shipping. It was used for less than 10k miles.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 04-28-2025, 10:24 PM
Replies: 3
Views: 1,054
Posted By L78toLT1
I haven't done a write-up, but if someone hasn't...

I haven't done a write-up, but if someone hasn't already done one, I could probably be talked into doing it. My mods will make it difficult to do a detailed, step by step procedure for a stock car,...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 04-24-2025, 10:43 PM
Replies: 3
Views: 1,054
Posted By L78toLT1
While I haven't pulled the oil pan with the motor...

While I haven't pulled the oil pan with the motor in the car, I have pulled the motor out the top, multiple times. I can have it out of the car and mounted on an engine stand in a leisurely 3 - 4...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 03-26-2025, 03:24 PM
Replies: 19
Views: 3,798
Posted By L78toLT1
The Kooks "high-flow" cats can't handle much...

The Kooks "high-flow" cats can't handle much boost. Their Greens seem to hold up pretty well at my power level (low-mid 700 whp).
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 01-17-2025, 01:50 PM
Replies: 1
Views: 2,761
Posted By L78toLT1
1160324

1160324
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 01-17-2025, 01:47 PM
Replies: 0
Views: 2,528
Posted By L78toLT1
ARP main stud kit for LT1/LT4

ARP main stud kit p/n 234-5802. Used for ~15k miles. Dropped valve took out my motor and I purchased turn-key shortblock. Studs are as new. $150 obo
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 01-17-2025, 01:01 PM
Replies: 1
Views: 2,761
Posted By L78toLT1
Callies H Beam Rods & Diamond wrist pins

These are the Callies rods and Diamond pins used with the GPI LT1 drop-in piston and rod combo. The rods and pins were run for approximately 15k miles and are in perfect condition. Even the rod...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-15-2024, 10:18 AM
Replies: 16,995
Views: 6,406,656
Posted By L78toLT1
Objective evidence indicates that you shouldn't...

Objective evidence indicates that you shouldn't have been stupid enough to think that 450hp would suffice either! BTW, I resemble that remark also, lol
Forum: Transmission / Driveline 05-29-2024, 09:30 AM
Replies: 2
Views: 5,872
Posted By L78toLT1
Jack, I replaced the diff in my 2016, M6 car with...

Jack, I replaced the diff in my 2016, M6 car with a unit from a 2018. The part #'s were different, but I could not visibly see any differences, and I've been running the replacement diff for several...
Forum: Forced Induction 05-28-2024, 01:16 PM
Replies: 0
Views: 3,494
Posted By L78toLT1
Magnuson 2300 intercooler brick

Does anyone have any Maggie 2300 parts laying around? I need a right hand intercooler brick. Mine has a very slight leak that my radiator shop can't repair.
Forum: Forced Induction Discussions 05-09-2024, 09:04 AM
Replies: 21
Views: 3,963
Posted By L78toLT1
Good luck! If the ecm is the issue, there are a...

Good luck! If the ecm is the issue, there are a few tricks you'll need to know in order to get the new ecm to play nice with the rest of the car, especially if the car is a M6. I can walk you thru...
Forum: Forced Induction Discussions 05-08-2024, 10:04 AM
Replies: 21
Views: 3,963
Posted By L78toLT1
Noid lights

Noid lights
Forum: Forced Induction Discussions 05-08-2024, 10:03 AM
Replies: 21
Views: 3,963
Posted By L78toLT1
When troubleshooting my car, I picked up a new...

When troubleshooting my car, I picked up a new injector wire harness so I could check the injector signal without having to pull off the blower. It ain't particularly easy, but on my 2300 Maggie...
Forum: Forced Induction Discussions 05-08-2024, 09:54 AM
Replies: 21
Views: 3,963
Posted By L78toLT1
When I lost fuel injection on the rh bank, the...

When I lost fuel injection on the rh bank, the issue was a bad ecm
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-01-2024, 10:25 PM
Replies: 33
Views: 9,878
Posted By L78toLT1
I've swapped cams in these cars, and believe you...

I've swapped cams in these cars, and believe you me, you'd be camped out on that dealers lot quite a while replacing the cam and associated hardware in a parking lot, on jacks.
For what it's worth,...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-24-2024, 03:52 PM
Replies: 32
Views: 7,351
Posted By L78toLT1
The OP's son is a salesman. I imagine that he...

The OP's son is a salesman. I imagine that he misinterpreted the tech's comment on oil recommdations. It would be strange for the dealership to purchase oil in a grade not recommended for the...
Forum: Forced Induction Discussions 03-14-2024, 04:58 PM
Replies: 24
Views: 3,145
Posted By L78toLT1
I really like how neat and tidy that Whipple 3.0...

I really like how neat and tidy that Whipple 3.0 looks! It doesn't appear that hang over the valve covers as much as a 2650 Maggie. The intercooler plumbing is much neater also.
Forum: ZL1 Discussions 03-07-2024, 06:21 PM
Replies: 13
Views: 2,353
Posted By L78toLT1
I don't know, Arpad. Those Supercar3's suck in...

I don't know, Arpad. Those Supercar3's suck in the rain, but other than that they're pretty good.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 02-21-2024, 10:30 AM
Replies: 44
Views: 8,816
Posted By L78toLT1
If you ceramic coat your headers, you shouldn't...

If you ceramic coat your headers, you shouldn't have any starter issues. I installed all of the mods in my signature around 25k miles ago. The only heat related issue I have experienced is one...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 02-01-2024, 05:03 PM
Replies: 1
Views: 790
Posted By L78toLT1
If you're looking for catless connection pipes,...

If you're looking for catless connection pipes, you're probably out of luck. Most, if not all header manufacturers only offer catted pipes these days.
Forum: General Automotive + Other Cars Discussion 01-19-2024, 07:02 PM
Replies: 200
Views: 131,551
Posted By L78toLT1
Maybe not gas v steam old, but I'm guessing...

Maybe not gas v steam old, but I'm guessing you're powerglide old, or close to it anyway. Btw: I resemble that last remark myself!
Forum: ZL1 Discussions 01-01-2024, 05:27 PM
Replies: 99
Views: 34,761
Posted By L78toLT1
[QUOTE=ohsmily;11392426]In other fresh news....WE...

[QUOTE=ohsmily;11392426]In other fresh news....WE LANDED ON THE MOON!
That's a good one that I'm going to have to remember for future reference!
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-01-2024, 02:33 PM
Replies: 24
Views: 2,590
Posted By L78toLT1
I was wondering the same thing. I'll bet the OP...

I was wondering the same thing. I'll bet the OP has oem Supercar3's and misread the sizes on the fronts
Forum: ZL1 Discussions 12-25-2023, 12:07 PM
Replies: 10
Views: 3,853
Posted By L78toLT1
I would check if the ecm has been flashed. If it...

I would check if the ecm has been flashed. If it has, the car almost certainly has been previously modified and returned to stock to sell.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-24-2023, 09:06 AM
Replies: 16
Views: 11,472
Posted By L78toLT1
Regarding cars as investments, here's my...

Regarding cars as investments, here's my experience. I was a Ford guy in my younger years. I specialized in '69 - '70 Mustangs and owned all of the desirable versions including boss 302 & 429s and...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 08:00 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2025, vBulletin Solutions, Inc.