Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Showing results 1 to 29 of 29
Search took 0.01 seconds. Search: Posts Made By: Eastbaycamaro
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-20-2023, 05:58 AM
Replies: 26
Views: 1,905
Posted By Eastbaycamaro
Wow they sent you a new shaft. I am going to call...

Wow they sent you a new shaft. I am going to call them when I get a chance to see what they say. And yes I was reading your thread good read. I am thinking about going to CF but I use the car as a...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-20-2023, 05:43 AM
Replies: 26
Views: 1,905
Posted By Eastbaycamaro
I am dealing with vibration problems as well. I...

I am dealing with vibration problems as well. I got the gulf coast 3.5 aluminum shaft. I sent it back and had it rebalance on their new balancing maching with seems to help a bit but I still get...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-03-2023, 07:50 AM
Replies: 33
Views: 9,622
Posted By Eastbaycamaro
If you are not drag racing I think you will be...

If you are not drag racing I think you will be fine with 3.91 and the stock posi unit. I broke the spider gears on my stock posi unit after a lot of abuse on the street and the 1/4 track. Also my car...
Forum: USA - California 06-09-2023, 06:02 AM
Replies: 22
Views: 8,178
Posted By Eastbaycamaro
Did my smog ck 3weeks ago. I just reloaded my...

Did my smog ck 3weeks ago. I just reloaded my stock tune with hp tuners and drove for a week. The EV monitor didn’t reset but I had no pending fault codes and it passed smog ck.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-04-2023, 07:28 AM
Replies: 40
Views: 4,969
Posted By Eastbaycamaro
Good deal glad to see that you got it fixed.

Good deal glad to see that you got it fixed.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-03-2023, 02:29 PM
Replies: 40
Views: 4,969
Posted By Eastbaycamaro
Since you removing your oil pan you might want...

Since you removing your oil pan you might want take a look at the pressure relief on the oil pan. It should be on the left side of the pan with a spray shield. My ls3 had it and I used a plug ...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-02-2023, 07:31 AM
Replies: 40
Views: 4,969
Posted By Eastbaycamaro
What brand oil pump are you using. Also if it’s a...

What brand oil pump are you using. Also if it’s a Melling pump what color spring are you using. I am wondering if the oil pump bypass valve is sticking and bypassing oil at low engine speeds.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-17-2023, 08:41 AM
Replies: 2
Views: 496
Posted By Eastbaycamaro
.025

.025
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 12-18-2022, 06:13 PM
Replies: 355
Views: 34,950
Posted By Eastbaycamaro
No vibrations with the stock set up. Going to...

No vibrations with the stock set up. Going to look at either shimming the trans mount or using offset differential bushing.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 12-18-2022, 03:49 PM
Replies: 355
Views: 34,950
Posted By Eastbaycamaro
Yes it is.

Yes it is.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 12-18-2022, 07:56 AM
Replies: 355
Views: 34,950
Posted By Eastbaycamaro
I got a 1 piece aluminum shaft from gulf coast...

I got a 1 piece aluminum shaft from gulf coast and it vibrates like crazy about 80ish. I also have a steel drive shaft and same thing. Going to look at adjusting the pinion angle.
Forum: 5th Gen Camaro SS LS LT General Discussions 12-18-2022, 07:42 AM
Replies: 47
Views: 6,351
Posted By Eastbaycamaro
I got BMR Trailing Arms, Toe Rods, Cradle...

I got BMR Trailing Arms, Toe Rods, Cradle bushings and Qa1 double adjustable shocks and my car would still wheel hop with street tires or drag radials. I broke spider gears then upgrade to tru trac...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-28-2022, 08:12 AM
Replies: 24
Views: 2,357
Posted By Eastbaycamaro
If you are running a stock drive shaft then you...

If you are running a stock drive shaft then you won’t need the driveshaft loop extension. I got a metro loop with a after market driveshaft on my m6 with a sonnax flange and it needs the loop...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-02-2022, 05:51 AM
Replies: 19
Views: 2,443
Posted By Eastbaycamaro
If I recall correctly the drain and fill plugs...

If I recall correctly the drain and fill plugs have a o-ring seal. In you case maybe the drain plug o-ring needs to be replaced
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-26-2022, 07:19 AM
Replies: 355
Views: 34,950
Posted By Eastbaycamaro
I am looking at either gulf coast or pstds 3.5...

I am looking at either gulf coast or pstds 3.5 aluminum. Currently have a 3x.083 mild steel with 1350 for the strange s60 rear and a sonnax 1350 to tr6060 Not to happy with it seems to vibrate at...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-05-2022, 06:07 AM
Replies: 47
Views: 5,502
Posted By Eastbaycamaro
It’s not to bad of a job. Might want to mark the...

It’s not to bad of a job. Might want to mark the position of the drive shaft to the trans and rear diff flange before you remove it. The trans gets very close to the tunnel on the passenger side...
Forum: Dragstrip and Launch Techniques Discussion 04-03-2022, 03:09 PM
Replies: 10
Views: 1,929
Posted By Eastbaycamaro
That’s awesome

That’s awesome
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-03-2022, 03:06 PM
Replies: 47
Views: 5,502
Posted By Eastbaycamaro
The other thing I notice with my rxt is that...

The other thing I notice with my rxt is that there is some rattling noise about 1600 rpm. I read that the rxt maybe a bit noisy. I will find out if it’s the clutch that’s noisy after I change it out....
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-03-2022, 08:24 AM
Replies: 47
Views: 5,502
Posted By Eastbaycamaro
I notice after I got the rxt that it’s a solid...

I notice after I got the rxt that it’s a solid hub on both clutch disk. After that I broke my axle/spider gears then upgraded to Eaton trutrac and motive 4:10 and after about 7 passes I broke a bunch...
Forum: Transmission / Driveline 04-03-2022, 08:12 AM
Replies: 1
Views: 1,022
Posted By Eastbaycamaro
I got one for sale $450

I got one for sale $450
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-25-2022, 03:31 PM
Replies: 47
Views: 5,502
Posted By Eastbaycamaro
Ram single disk set up with the spring hub

Ram single disk set up with the spring hub
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-25-2022, 07:22 AM
Replies: 47
Views: 5,502
Posted By Eastbaycamaro
I will be removing my McLeod RXT twin disks next...

I will be removing my McLeod RXT twin disks next week and put it up for sale. Got about 15 passes at the drag strip. It is a solid hub design pn# 6932-07
Forum: Local Marketplace 03-20-2022, 08:09 AM
Replies: 0
Views: 574
Posted By Eastbaycamaro
Trutrac $475

Trutrac for sale $450
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-20-2022, 07:49 AM
Replies: 10
Views: 2,174
Posted By Eastbaycamaro
I tore into it. It was a project. Had to drop the...

I tore into it. It was a project. Had to drop the front sub frame about 3-4 inches and raise the motor as high as it could go. Removed the radiator, water pump, and oil cooler. Loosen and slide the...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-19-2022, 09:12 AM
Replies: 10
Views: 2,174
Posted By Eastbaycamaro
I had about 60k and did it myself. I tried the...

I had about 60k and did it myself. I tried the oil pressure sensor but no help. Then I heard the lifters clacking so I know the oil pressure was low. Did all the work myself
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-19-2022, 09:06 AM
Replies: 10
Views: 2,174
Posted By Eastbaycamaro
I had to change my oil pump

I had to change my oil pump
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-19-2022, 09:01 AM
Replies: 9
Views: 1,418
Posted By Eastbaycamaro
What axles are you going to use with the tru trac

What axles are you going to use with the tru trac
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-10-2022, 07:08 AM
Replies: 9
Views: 1,418
Posted By Eastbaycamaro
Removed my diff last week. I pulled the axles....

Removed my diff last week. I pulled the axles. Disconnect the toe link,upper control arm and lower control arm at spindle. Remove the abs sensor and you should be able to move the spindle out far...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 01-28-2022, 06:26 AM
Replies: 11
Views: 1,559
Posted By Eastbaycamaro
Ck out...

Ck out https://www.gulfcoastdriveshaft.com/camaro-gen-5/
They seem to have a one piece drive shaft that bolts on with no adapters.
Showing results 1 to 29 of 29

 
Forum Jump

All times are GMT -5. The time now is 06:01 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.