Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Showing results 1 to 27 of 27
Search took 0.01 seconds. Search: Posts Made By: CT23
Forum: Suspension / Brakes / Chassis 01-07-2021, 06:23 PM
Replies: 2
Views: 1,057
Posted By CT23
What did you end up doing? I don't have any pics...

What did you end up doing? I don't have any pics at the moment, but this is an issue I'm working on currently.
Forum: Suspension / Brakes / Chassis 01-07-2021, 06:21 PM
Replies: 70
Views: 29,641
Posted By CT23
Don't have any miles yet, but running factory ZL1...

Don't have any miles yet, but running factory ZL1 20X10 from with 285/35 and 20x11 rear with 305/35 don't seem to have any clearance issues. On the front, I did adjust the factory camber bolt to give...
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 12-24-2019, 02:59 AM
Replies: 1
Views: 1,734
Posted By CT23
Well falls about over. Hope you found an answer....

Well falls about over. Hope you found an answer. I have an AGP TT ZL1 myself. Don't have that cam. I think there's a few guys that had/have that cam. From what I remember, it works just not ideal if...
Forum: Forced Induction - V8 12-06-2019, 05:03 PM
Replies: 279
Views: 54,691
Posted By CT23
With the GFB boost controller, you can use a...

With the GFB boost controller, you can use a clutch position sensor to switch you through the presets you have saved. It doesn't pay attention to what gear you are actually in though. Just switches...
Forum: Forced Induction - V8 08-21-2019, 12:49 PM
Replies: 279
Views: 54,691
Posted By CT23
I think to reach its full potential higher would...

I think to reach its full potential higher would be better, with the right setup. My rev limiter is 7000, and my current tune didn't seem like spinning it higher would've helped. I gained 29hp and...
Forum: Forced Induction - V8 08-20-2019, 05:57 PM
Replies: 279
Views: 54,691
Posted By CT23
It had to be modded. The bottom pic is how it...

It had to be modded. The bottom pic is how it lined up before mod. The ZL1 hood insert also had to be notched to clear.
Forum: Forced Induction - V8 08-20-2019, 12:36 PM
Replies: 279
Views: 54,691
Posted By CT23
I went with a stg2 turbo cam from GP Tuning. I'm...

I went with a stg2 turbo cam from GP Tuning. I'm happy with it. Still running the stock npp exhaust on my '13 ZL1 with the AGP kit.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-11-2019, 01:37 PM
Replies: 1,469
Views: 157,433
Posted By CT23
#'s in

Here is what the shop gave me for comparison. This was on E60 no meth, both pulls were 20# of boost. They did mention that it is difficult to load a car for comparison. Whatever that means. Since...
Forum: Forced Induction - V8 06-11-2019, 01:15 PM
Replies: 475
Views: 140,910
Posted By CT23
The LS3 manifolds have a lip that the ZL1 does...

The LS3 manifolds have a lip that the ZL1 does not. The turbo adapters sit in this lip. So you can use them, but you will have to somehow get that lip in there. Other have done it. I put the kit on...
Forum: Forced Induction - V8 06-03-2019, 03:25 PM
Replies: 8
Views: 1,073
Posted By CT23
I installed an AGP kit here on my '13 ZL1....

I installed an AGP kit here on my '13 ZL1. Quality is good, fitment from what I gather is better than a lot of other aftermarket parts company. I'm happy with the kit, as are most of the people I've...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-03-2019, 02:19 PM
Replies: 1,469
Views: 157,433
Posted By CT23
Charge pipe from my intercooler doesn't line up...

Charge pipe from my intercooler doesn't line up or clear the insert of the ZL1 hood. The shop is having a new one fabbed up to line up and hopefully not trim the hood. Hoping to have some numbers...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-14-2019, 01:18 PM
Replies: 1,469
Views: 157,433
Posted By CT23
Finally getting around to putting the X1 on that...

Finally getting around to putting the X1 on that I won in the tax raffle. Having the shop check the tune before they install it, install, tune and dyno again. Hoping to have before and after #'s on...
Forum: Suspension / Brakes / Chassis 02-16-2019, 11:45 AM
Replies: 94
Views: 30,162
Posted By CT23
Chance of another production run on these?

Chance of another production run on these?
Forum: USA - Northwest / Pacific Northwest 02-14-2019, 06:32 PM
Replies: 268
Views: 47,191
Posted By CT23
:emoticon3:Crickets.....

:emoticon3:Crickets.....
Forum: Forced Induction - V8 02-14-2019, 02:43 PM
Replies: 475
Views: 140,910
Posted By CT23
Turbos: Garrett 57/57 GTX3076r Motor (CI):...

Turbos: Garrett 57/57 GTX3076r
Motor (CI): Stock LSA 376
Cam: GP Tuning stg 2 TT
Trans: Stock M6, Monster LT1-S triple clutch
Fuel System: AGP dual Fore
Meth: Not yet
E85: Not yet
Installed/...
Forum: Forced Induction - V8 02-14-2019, 01:07 PM
Replies: 273
Views: 400,757
Posted By CT23
Finally some #'s. Right where AGP told me I'd be...

Finally some #'s. Right where AGP told me I'd be when deciding what turbos to go with. This was on 92, correction factor of .98
Was shooting for 14# pull, hit overboost @ 14.9# on this one. Turned...
Forum: Forced Induction - V8 05-13-2018, 09:33 PM
Replies: 279
Views: 54,691
Posted By CT23
From the engine bay you can't see much. Here are...

From the engine bay you can't see much. Here are some pics of when I was putting motor back in. Do not have to pull the motor, I was doing other engine mods that were easier with it out. The engine...
Forum: Forced Induction - V8 04-14-2018, 03:48 AM
Replies: 7
Views: 1,480
Posted By CT23
Ha, it is. But it's only lightly resting on the...

Ha, it is. But it's only lightly resting on the door. Still have the cherry picker holding most of the weight.
Forum: Forced Induction - V8 04-14-2018, 12:11 AM
Replies: 7
Views: 1,480
Posted By CT23
I'm just removing supercharger and tensioner....

I'm just removing supercharger and tensioner. Most of the way done with the install.
Forum: Tuning / Diagnostics -- engine and transmission 03-02-2018, 09:18 PM
Replies: 1
Views: 1,053
Posted By CT23
Nobody? Did you get it all wired in? I should...

Nobody? Did you get it all wired in?
I should be installing mine next week. If I get it figured out I'll check back in here.
Forum: Forced Induction - V8 02-07-2018, 09:37 AM
Replies: 279
Views: 54,691
Posted By CT23
https://www.facebook.com/groups/578503012333537/ ...

https://www.facebook.com/groups/578503012333537/
Here is the link
Forum: Forced Induction - V8 02-07-2018, 08:32 AM
Replies: 279
Views: 54,691
Posted By CT23
If it is the "Turbo Camaro Owners Group (5th-6th...

If it is the "Turbo Camaro Owners Group (5th-6th Gen)" it is a closed group. One of the admins has to add you. I'll throw your cam5 user name on the group page for the admins to look you up.
Forum: USA - Northwest / Pacific Northwest 12-17-2017, 12:32 PM
Replies: 268
Views: 47,191
Posted By CT23
Will do. Need to stop by and see Brent as well....

Will do. Need to stop by and see Brent as well. Only chatted through fb and the phone.
Forum: USA - Northwest / Pacific Northwest 12-10-2017, 11:57 AM
Replies: 268
Views: 47,191
Posted By CT23
Do you hang with other Camaro buddies or groups? ...

Do you hang with other Camaro buddies or groups? Not yet
Any mods planned in this off season? YEP!!! AGP twin turbo w/supporting mods ordered

If you are on Facebook, what groups are you in? ...
Forum: USA - Northwest / Pacific Northwest 12-10-2017, 09:16 AM
Replies: 8
Views: 1,636
Posted By CT23
Welcome. Yeah, the fb group is more active than...

Welcome. Yeah, the fb group is more active than this regional forum. Not exactly local, but Wongs Performance in Vancouver, WA is a name that has come up quite a bit in my searches on other sites. I...
Forum: Forced Induction - V8 11-24-2017, 07:57 PM
Replies: 475
Views: 140,910
Posted By CT23
Weak moment before heading to work tonight....

Weak moment before heading to work tonight. Instead of just seeing what it looked like in the cart, I hit the purchase button. Black Friday shopping done, AGP kit ordered!!! 57/57 Garret BB per...
Forum: USA - Northwest / Pacific Northwest 07-24-2015, 12:03 AM
Replies: 2,091
Views: 277,216
Posted By CT23
Just picked up a 2010 SS 6spd. Joined forum to...

Just picked up a 2010 SS 6spd. Joined forum to research future upgrades. Read about fb club sent request to join.
Showing results 1 to 27 of 27

 
Forum Jump

All times are GMT -5. The time now is 10:38 PM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.