Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 2 1 2
Showing results 1 to 30 of 40
Search took 0.01 seconds. Search: Posts Made By: 11REDSS
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-23-2024, 07:29 AM
Replies: 6
Views: 261
Posted By 11REDSS
I found it easier to remove the hood as well. ...

I found it easier to remove the hood as well.
Drill 2 alignment holes in the hinges to get everything lined back up easier and you are good.
Forum: Forced Induction - V8 03-30-2024, 05:53 AM
Replies: 0
Views: 181
Posted By 11REDSS
Win max wiring help

I am wiring up the winmax unit from nitrous outlet.
Where is everyone pulling the tach signal from?
I searched on line and see two different answers one says the purple wire on the coil pack...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-05-2024, 05:18 PM
Replies: 8
Views: 603
Posted By 11REDSS
I used this post as a pretty much step by step...

I used this post as a pretty much step by step instructions
https://www.camaro5.com/forums/showthread.php?t=125123
And this one
https://www.camaro5.com/forums/showthread.php?t=385577&page=5
When...
Forum: Cosmetics and Lighting Modification Discussions 11-18-2023, 06:40 AM
Replies: 22
Views: 1,703
Posted By 11REDSS
Around here windshield will usually get you...

Around here windshield will usually get you pulled over also can be harder to see at night. Doctors notes do help unless the police are in a mood.

I went 20% all the way all windows but...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-02-2023, 05:21 PM
Replies: 95
Views: 31,422
Posted By 11REDSS
I wouldn’t think so because you would only be...

I wouldn’t think so because you would only be removing one end of the loop and coolant would go out to the air. be careful remove the large plug on the side of the block there was an issue with...
Forum: 5th Gen Camaro SS LS LT General Discussions 10-28-2023, 12:45 PM
Replies: 1,085
Views: 74,494
Posted By 11REDSS
installed the rsm front crash bar today. Also...

installed the rsm front crash bar today. Also found a good solution for the rear crash bar, I bought the parachute mount kit from motion raceworks and mounted the crash bar portion of it and did not...
Forum: Suspension / Brakes / Chassis 10-07-2023, 03:49 PM
Replies: 0
Views: 495
Posted By 11REDSS
Rear crash bar

Has anyone tried to use the tubular bumper part of a parachute mount kit for a rear crash bar and not installed the parachute mount part? Is it hidden behind the licencse plate or is there still the...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-31-2023, 05:57 PM
Replies: 146
Views: 15,511
Posted By 11REDSS
I’m interested as well depending on price

I’m interested as well depending on price
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-17-2023, 06:11 AM
Replies: 7
Views: 1,030
Posted By 11REDSS
Ok thanks guys I am just going to put a bolt in...

Ok thanks guys I am just going to put a bolt in there to plug it just for piece of mind.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-11-2023, 03:13 PM
Replies: 7
Views: 1,030
Posted By 11REDSS
what goes here

I changed the valley pan on my l99 to a ls3 and I can not remember what if anything goes in this threaded hole, its on the back passenger side on the china rail.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-19-2023, 09:12 PM
Replies: 5
Views: 475
Posted By 11REDSS
Nope that is their stage 1 cam.

Nope that is their stage 1 cam.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-19-2023, 05:57 PM
Replies: 5
Views: 475
Posted By 11REDSS
First fireup with new cam

First fireup with the GPI SS1 cam on an initial tune

https://youtu.be/UrvI6XLzHW4

Can’t wait to actually drive it.
Forum: Garage / Tools Discussions 03-02-2023, 03:57 PM
Replies: 17
Views: 3,871
Posted By 11REDSS
I used the bottle that came with the quick jacks...

I used the bottle that came with the quick jacks and over killed or at least I thought the amount on the fittings, one leaked so I had to redo it and let it sit overnight before it would seal.
Forum: Garage / Tools Discussions 02-25-2023, 09:00 AM
Replies: 17
Views: 3,871
Posted By 11REDSS
Local auto parts store ATF

Local auto parts store ATF
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 02-12-2023, 05:22 PM
Replies: 56
Views: 3,502
Posted By 11REDSS
I run a sound ordnance amp its 75 watts x 4...

I run a sound ordnance amp its 75 watts x 4 channels. It’s loud enough for what I need. I still run the BA speakers as well. I run an aftermarket radio in mine and do not notice the center speaker...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 02-12-2023, 11:06 AM
Replies: 56
Views: 3,502
Posted By 11REDSS
I tired pming you the company but it keeps...

I tired pming you the company but it keeps getting stared out. Google search FARK for camaro and it should come up, the board / amp mount is also from the same vendor you have to look around on...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 02-12-2023, 07:52 AM
Replies: 56
Views: 3,502
Posted By 11REDSS
If you have the Boston Acoustics sound system in...

If you have the Boston Acoustics sound system in camaro it’s pretty easy, they make a plug and play harness to add an amp. They also have precut boards for you to mount an amp in the BA amp location...
Forum: Garage / Tools Discussions 02-06-2023, 05:43 PM
Replies: 17
Views: 3,871
Posted By 11REDSS
I have the 5000tlx and i have no problem sliding...

I have the 5000tlx and i have no problem sliding them under the camaro. I do not drive over them, just slide them in from the sides once parked. Lifts it up high enough to do exhaust work under the...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-09-2022, 06:48 AM
Replies: 3
Views: 1,110
Posted By 11REDSS
Why not just use an add a fuse circuit with a...

Why not just use an add a fuse circuit with a switch on it that you hide. That way you do not cut or splice into the wiring and then you can turn it on a and off as you like?
Forum: 5th Gen Camaro SS LS LT General Discussions 09-20-2022, 08:57 AM
Replies: 3
Views: 1,836
Posted By 11REDSS
This is the one I went with. I am running a skar...

This is the one I went with. I am running a skar SVR series 12 and its enough for me.
Forum: 5th Gen Camaro SS LS LT General Discussions 09-10-2022, 12:47 PM
Replies: 26,840
Views: 7,407,800
Posted By 11REDSS
Just took it for a ride, rear end feels really...

Just took it for a ride, rear end feels really solid now, definitely worth the upgrade.
Forum: 5th Gen Camaro SS LS LT General Discussions 09-07-2022, 02:45 PM
Replies: 26,840
Views: 7,407,800
Posted By 11REDSS
Haven’t pulled it out of the garage yet. ...

Haven’t pulled it out of the garage yet. Hopefully get to do that this weekend.
Forum: 5th Gen Camaro SS LS LT General Discussions 09-05-2022, 03:32 PM
Replies: 26,840
Views: 7,407,800
Posted By 11REDSS
Did the BMR toe rods, trailing arms, energy...

Did the BMR toe rods, trailing arms, energy suspension differential bushings, prothane rear cradle bushings today.
Forum: 5th Gen Camaro SS LS LT General Discussions 09-04-2022, 06:05 PM
Replies: 9
Views: 2,240
Posted By 11REDSS
Had one that was metal pipe and tarps that were...

Had one that was metal pipe and tarps that were cinched strapped to the poles. Tarp cam down in middle of winter due to high winds and snow..now I have to repaint my 76 Dodge Dart from the scratches...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-02-2022, 11:21 AM
Replies: 3
Views: 1,145
Posted By 11REDSS
thank you

thank you
Forum: 5th Gen Camaro SS LS LT General Discussions 07-02-2022, 10:29 AM
Replies: 3
Views: 1,145
Posted By 11REDSS
Voltage question

Is it normal when you are at idle to have your in car volt meter reading around 12 volts then when you start to move it jumps up to 14 like it should? Kind of new to GM motors. So i am not sure how...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2022, 03:42 PM
Replies: 1
Views: 715
Posted By 11REDSS
Rally stripe locations

Can someone post the measurements for how far apart the rally stripes are on the hood and on the rear deck.
Thank you
Forum: 5th Gen Camaro SS LS LT General Discussions 02-22-2022, 01:55 PM
Replies: 8
Views: 4,548
Posted By 11REDSS
You might look at subth*^p, I have their single...

You might look at subth*^p, I have their single 12” ported box for in a 2012 SS, with the 12 skar SVR running. The only issue is it takes up some room in the trunk and it can be difficult to get into...
Forum: 5th Gen Camaro SS LS LT General Discussions 01-25-2022, 06:33 AM
Replies: 26
Views: 4,314
Posted By 11REDSS
Agree, I used ARP Studs on mine, easiest headers...

Agree, I used ARP Studs on mine, easiest headers I have ever put on a vehicle.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-29-2021, 07:52 PM
Replies: 31
Views: 4,294
Posted By 11REDSS
Arp 434-1301 was the kit I used

Arp 434-1301 was the kit I used
Showing results 1 to 30 of 40
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 01:37 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.