Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Emblempros
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.07 seconds.
Search: Posts Made By: laynlo15
Forum: Forced Induction Discussions Yesterday, 04:05 PM
Replies: 46
Views: 2,223
Posted By laynlo15
Ted I just noticed you are still running the old...

Ted I just noticed you are still running the old 4" intake tube instead of the Roto-Fab Big Gulp. I think you might have made the 1000 rwhp on that 70mm and the Gulp.
Forum: Forced Induction Discussions Yesterday, 03:59 PM
Replies: 46
Views: 2,223
Posted By laynlo15
Ted those are still great results and he has a...

Ted those are still great results and he has a bad ass ride. Gonna be hard to control that power on the street. Congrats on a wicked build and glad the 2650 worked out so well, I love mine and I'm...
Forum: Forced Induction Discussions 12-04-2019, 10:38 PM
Replies: 4
Views: 232
Posted By laynlo15
The 2650s are pretty stellar.

The 2650s are pretty stellar.
Forum: Dragstrip and Launching Discussion 12-04-2019, 10:34 PM
Replies: 5
Views: 123
Posted By laynlo15
He's a buddy of mine and I just texted him...

He's a buddy of mine and I just texted him earlier about the 325R, the only thing he did was move the wiring harness in the inner fender well of the drivers side. No rubbing on his 10" wheel.
Forum: Dragstrip and Launching Discussion 12-04-2019, 02:59 PM
Replies: 5
Views: 123
Posted By laynlo15
You can run the 325 MT as it will fit under your...

You can run the 325 MT as it will fit under your car and its basically the same height as the 275MT just a bunch wider. Gen6Mike is running it on his 8 second Camaro.
Forum: Dragstrip and Launching Discussion 12-04-2019, 09:39 AM
Replies: 2,044
Views: 401,793
Posted By laynlo15
Nice pass Alpha

Nice pass Alpha
Forum: Forced Induction Discussions 12-04-2019, 07:51 AM
Replies: 4
Views: 232
Posted By laynlo15
Wish you could have went with Magnuson but...

Wish you could have went with Magnuson but congrats on your purchase as that's a good percentage off.
Forum: Forced Induction Discussions 12-03-2019, 08:42 PM
Replies: 12
Views: 280
Posted By laynlo15
If your only dropping less then a 1/4" it should...

If your only dropping less then a 1/4" it should work.
Forum: ZL1 Discussions 12-02-2019, 11:18 PM
Replies: 177
Views: 16,996
Posted By laynlo15
I have the BMR mounts and it didn't change...

I have the BMR mounts and it didn't change anything on engine placement. Cleared my headers and made more room to work underneath if needed.
Forum: Dragstrip and Launching Discussion 12-02-2019, 04:21 PM
Replies: 42
Views: 1,911
Posted By laynlo15
Geeeezzzz Louise, that's another crazy ass pass...

Geeeezzzz Louise, that's another crazy ass pass and almost all was gained in the 1/8 mile. That 3400 lbs with you in the car still freaks me out. I know you way lighter then me but my 3890 dwarfs...
Forum: Forced Induction Discussions 12-02-2019, 03:58 PM
Replies: 12
Views: 280
Posted By laynlo15
Teddy skipped the 98mm and went to the 95mm and...

Teddy skipped the 98mm and went to the 95mm and that's how it was tuned. It probably won't need a lot of change but you should call your tuner and see if he could do that for free since you just...
Forum: Forced Induction Discussions 12-02-2019, 02:14 PM
Replies: 12
Views: 280
Posted By laynlo15
Teddy you meant 95 correct? It will probably need...

Teddy you meant 95 correct? It will probably need just a little tweaking.
Forum: Forced Induction Discussions 12-01-2019, 07:01 PM
Replies: 11
Views: 805
Posted By laynlo15
Very cool and tight fit but that's a good thing.

Very cool and tight fit but that's a good thing.
Forum: Forced Induction Discussions 11-30-2019, 06:15 PM
Replies: 19
Views: 1,289
Posted By laynlo15
Not sure how much the 112 really helps and its a...

Not sure how much the 112 really helps and its a bunch out of pocket.
Forum: Forced Induction Discussions 11-29-2019, 10:13 PM
Replies: 15
Views: 469
Posted By laynlo15
I don't know but thinking about 550 rwhp which I...

I don't know but thinking about 550 rwhp which I had when I first put my Maggie 2300 on and all street tires are useless and that's why my Camaro makes 850 rwhp and I just drag race it 99% of the...
Forum: ZL1 Discussions 11-29-2019, 10:55 AM
Replies: 25
Views: 1,132
Posted By laynlo15
I have a buddy that put one of our Magnuson 2300...

I have a buddy that put one of our Magnuson 2300 Radx on his 16 Denali Truck, runs great on E85 and made 560 rwhp and ran 12.60s, not to bad but not on the Track Hawk level. Shit load of fun to...
Forum: ZL1 Discussions 11-28-2019, 08:05 AM
Replies: 22
Views: 794
Posted By laynlo15
They do make a difference for sure, DA and temps...

They do make a difference for sure, DA and temps are a huge factor for going fast but I ran my best et in low 80 degree temps at the LS Fest at 9.41@146 w/1.35 short time. I ran later in way better...
Forum: Forced Induction Discussions 11-28-2019, 07:50 AM
Replies: 30
Views: 1,172
Posted By laynlo15
About 180 trips on the bottom end but only 150 or...

About 180 trips on the bottom end but only 150 or so under boost with the 2300, obviously some were 1/8 mile, but only about 1/3 I would guess. Yep those big old cats hanging down there plus it did...
Forum: ZL1 Discussions 11-27-2019, 05:36 PM
Replies: 33
Views: 1,131
Posted By laynlo15
Here is an example our Copo Camaro's make about...

Here is an example our Copo Camaro's make about 1340 hp or about 1200 rwhp and they run high 7s and 3550 lbs and aren't streetable. So far 8.64 is the best et for a SS Camaro and Zl1 is a couple...
Forum: Forced Induction Discussions 11-27-2019, 03:38 PM
Replies: 30
Views: 1,172
Posted By laynlo15
Yes, went to long tubes with the new motor and...

Yes, went to long tubes with the new motor and still have the stock exhaust from the cats back with the big suit case muffler.
Forum: Forced Induction Discussions 11-27-2019, 12:16 AM
Replies: 30
Views: 1,172
Posted By laynlo15
We flogged my car and pushed it to the end and it...

We flogged my car and pushed it to the end and it made 700 stock motor with 2300 on 17 lbs of boost. We broke a couple of ring lands and ran 10.13@140 on the last 1/4 pass of the year (2018) and...
Forum: Dragstrip and Launching Discussion 11-27-2019, 12:03 AM
Replies: 31
Views: 2,045
Posted By laynlo15
My 149.82 was so close but it just didn't happen....

My 149.82 was so close but it just didn't happen. Conditions were right and I just couldn't get there. My 1-2 shift just wasn't on time and then short shifted to 3rd and you could here it on the...
Forum: Forced Induction Discussions 11-26-2019, 08:20 PM
Replies: 19
Views: 814
Posted By laynlo15
Awesome, car sounds great.

Awesome, car sounds great.
Forum: Dragstrip and Launching Discussion 11-26-2019, 03:18 PM
Replies: 17
Views: 884
Posted By laynlo15
Launch in second, slap it into auto and let it...

Launch in second, slap it into auto and let it go. That's how I've tried it.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 11-26-2019, 03:15 PM
Replies: 5
Views: 454
Posted By laynlo15
Very good point and tip of the day. thx

Very good point and tip of the day. thx
Forum: ZL1 Discussions 11-26-2019, 03:13 PM
Replies: 20
Views: 1,254
Posted By laynlo15
Its a Magnuson, just says TVS 2650 but you can...

Its a Magnuson, just says TVS 2650 but you can see it in the Video. Just saying.
Forum: Dragstrip and Launching Discussion 11-26-2019, 07:48 AM
Replies: 17
Views: 884
Posted By laynlo15
We actually have lots of guys with big power...

We actually have lots of guys with big power launching in 2nd as we just can't hook these cars in 1st.
Forum: ZL1 Discussions 11-24-2019, 09:21 PM
Replies: 20
Views: 1,254
Posted By laynlo15
GM did a great job on the stock exhaust but its...

GM did a great job on the stock exhaust but its not gonna flow for the kinda of hp Ted is putting down. Might be a little too much restriction. I ran my stock exhaust up to over 700 rwhp.
Forum: Dragstrip and Launching Discussion 11-24-2019, 02:15 PM
Replies: 31
Views: 2,045
Posted By laynlo15
Nick (guitarmegedden) just went 8.89@160 with his...

Nick (guitarmegedden) just went 8.89@160 with his twin turbo Gen6 Zl1 and did it with 17" Rs and stock Zl1 fronts. That's Z is bad for sure. Everybody has really picked up their game this year....
Forum: Dragstrip and Launching Discussion 11-23-2019, 05:35 PM
Replies: 31
Views: 2,045
Posted By laynlo15
Wow Jim that was a great pass and big mph....

Wow Jim that was a great pass and big mph. Congrats, I could not get my car to hook when it cooled off as we just had too much power down low and pig rich up top or I think I could have run over 150...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 07:56 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2019, vBulletin Solutions, Inc.