Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 16 of 16
Search took 0.01 seconds.
Search: Posts Made By: dereklburt
Forum: Forced Induction - V6 03-18-2017, 11:48 PM
Replies: 2
Views: 1,757
Posted By dereklburt
LFX turbo swap in Lotus- Vehicle Speed Sensor hook up? Help

So I finally got my car going but I have not been able to get it properly tuned. It had an initial tune but the car would only rev to 4000rpm and up until now, I have had several people trying to...
Forum: Forced Induction - V6 01-26-2017, 06:07 PM
Replies: 3
Views: 1,899
Posted By dereklburt
LFX turbo swap question-my throttle isn't opening all the way

Still trying to get a final tune on my Lotus Elise with a 2013 LFX and custom turbo. The car was not revving over 4000rpm and after countless hours of trying to figure out what was going on, we...
Forum: Tuning / Diagnostics -- engine and transmission 04-26-2016, 04:42 PM
Replies: 0
Views: 860
Posted By dereklburt
Engine swap-Tuning/ diagnostic help needed. 3.6 turbo in a Lotus Elise

I am hoping to get some help figuring what is going on with my car. Have a 2006 Lotus Elise with a 2013 3.6 V6 LFX direct injection engine swap and a custom turbo set up. Running a 6 speed manual.
...
Forum: Forced Induction - V6 04-24-2016, 09:18 PM
Replies: 2
Views: 1,578
Posted By dereklburt
Need some help -3.6 LFX turbo in Lotus Elise- tuning and fuel problems

I am hoping to get some help figuring what is going on with my car. Have a 2006 Lotus Elise with a 2013 3.6 LFX engine swap and a custom turbo set up. Running a 6 speed manual.

Have two...
Forum: Forced Induction - V6 03-25-2012, 07:28 AM
Replies: 472
Views: 59,963
Posted By dereklburt
Im very excited to see the outcome. I just put a...

Im very excited to see the outcome. I just put a turbo 3.6DI engine in my Lotus but I am still finishing it up. Not to steal the thread but I am considering trading in my older 2004 CTS V on a newer...
Forum: Tuning / Diagnostics -- engine and transmission 03-11-2012, 09:29 PM
Replies: 1
Views: 1,311
Posted By dereklburt
I need a GM wiring expert(in or near Michigan) to wire my car

I have a Lotus Elise that I swapped a 3.6L V6 Direct injection engine into. The engine is actually out of a 2009 Traverse but I then installed the the newer Camaro intake (which is the only...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 08-01-2011, 10:50 PM
Replies: 0
Views: 1,051
Posted By dereklburt
Mass Air Flow question

I am using a 2009 V6 Direct injection engine for a engine swap. The engine came from a Traverse, but it now has a camaro intake and will soon be turbocharged. The engine is the same as the Camaro but...
Forum: Forced Induction - V6 07-16-2011, 10:21 PM
Replies: 13
Views: 3,605
Posted By dereklburt
Yes I am putting the V6 in an Elise and adding a...

Yes I am putting the V6 in an Elise and adding a turbo. I am using the Saab 2.8V6 turbo exhaust manifolds. Same block as the 3.6L Here is a pic of the engine mounted in the car. Still a long way to...
Forum: Forced Induction - V6 07-10-2011, 09:28 PM
Replies: 13
Views: 3,605
Posted By dereklburt
turbo question-water and oil hookup for turbo

I am wondering where the best place is to hook up a water and oil supply for the turbo? I am mounting the engine transverse in a mid engine car and adding a turbo.
Thank you
Forum: Forced Induction - V6 03-12-2011, 11:07 PM
Replies: 17
Views: 5,059
Posted By dereklburt
Thanks, that is good to know. Did you just run...

Thanks, that is good to know. Did you just run the 1/8th or full quarter mile? What was your trap speed on 8psi?
Forum: Forced Induction - V6 03-09-2011, 08:18 PM
Replies: 17
Views: 5,059
Posted By dereklburt
I saw something about that. They must have had...

I saw something about that. They must have had some serious problems. It would be nice to see a run from a current kit. It sounds as if they thought they had things sorted out and didn't. The power...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 03-09-2011, 08:02 PM
Replies: 10
Views: 2,253
Posted By dereklburt
I plan on using a turbo with my set up and it...

I plan on using a turbo with my set up and it will also use a water to air intercooler as it is a mid engine car and it is difficult to get air to an air to air, but when I am eventually done, I will...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 03-08-2011, 09:47 PM
Replies: 10
Views: 2,253
Posted By dereklburt
Thanks for the tip. I guess I didn't realize that...

Thanks for the tip. I guess I didn't realize that the part number was also the size. I figured that I would measure the belt length needed by using a string but I didn't know as the newer belts are...
Forum: Forced Induction - V6 03-08-2011, 09:40 PM
Replies: 1
Views: 2,947
Posted By dereklburt
What size turbo for single turbo set up?

I was trying to look at different compressor maps and figure out what size turbo would be best for a single set up on the 3.6 DI. For starters, does anyone know what turbo STS is using? Based on my...
Forum: Forced Induction - V6 03-08-2011, 09:29 PM
Replies: 17
Views: 5,059
Posted By dereklburt
How high of boost on turbo?

I am looking at a single turbo set up for my car. I was talking to Vince at Trifecta about tuning and one of the potential limitations he mentioned was blowby at higher boost levels. Has anyone on...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 03-08-2011, 09:08 PM
Replies: 10
Views: 2,253
Posted By dereklburt
Help-Drive belt to eliminate AC and Power steering

I am doing a conversion with the 3.6 DI engine. I am eliminating the AC and power steering as I don't need them. Any ideas on what to use for a drive belt or where I could get one to fit? :iono:...
Showing results 1 to 16 of 16

 
Forum Jump

All times are GMT -5. The time now is 01:12 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.