Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Jason 98 TA
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.06 seconds.
Search: Posts Made By: xc_SS/RS
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-13-2019, 09:00 PM
Replies: 19
Views: 785
Posted By xc_SS/RS
You'll want to go bigger with a 416

You'll want to go bigger with a 416
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-06-2019, 11:25 AM
Replies: 5
Views: 227
Posted By xc_SS/RS
I've got one if you're interested! Went ZL1...

I've got one if you're interested! Went ZL1 instead since the livernois was somehow caught in USPS limbo

It's got deatschwerks 320 pumps as well as stock pumps
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-05-2019, 02:21 PM
Replies: 4
Views: 291
Posted By xc_SS/RS
Nice diy! I was going to try this when I did my...

Nice diy! I was going to try this when I did my fuel pump but wasn't sure how. I think to get it to run a long time you would change the prime time of the pump

Ive only seen the guys on...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-02-2019, 05:33 PM
Replies: 14
Views: 604
Posted By xc_SS/RS
I didn't notice an increase in road noise when I...

I didn't notice an increase in road noise when I installed the MGW. Make sure you use the included dynamat on the shifter arms and on the trans tunnel. I think that's key. I also put a piece around...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-01-2019, 03:54 PM
Replies: 14
Views: 604
Posted By xc_SS/RS
Also makes it easier to nail third properly at...

Also makes it easier to nail third properly at the drag strip... Not just a road course perk.

Get the MGW. You won't regret it
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-28-2019, 03:15 PM
Replies: 25
Views: 1,097
Posted By xc_SS/RS
I'd give it a shot but I have no clue how to...

I'd give it a shot but I have no clue how to mount a 2nd can safely lol

If you want to go against a mightymouse wild pcv can send one over and I'll install it after 1k miles with the mightmouse...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-27-2019, 03:21 PM
Replies: 25
Views: 1,097
Posted By xc_SS/RS
mightymouse wild pcv can has helped reduce the...

mightymouse wild pcv can has helped reduce the amount of oil that was getting to my intake manifold a lot. its basically bone dry now

the bracket isn't the best and i'm going to try and come up...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-14-2019, 11:20 AM
Replies: 21
Views: 714
Posted By xc_SS/RS
I've never had this issue and I've had a 160...

I've never had this issue and I've had a 160 tstat for 2-3 years now. I've driven in the snow and in teens/single digits temps with a vented hood. Did you fill from the top hose?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-13-2019, 09:20 AM
Replies: 6
Views: 362
Posted By xc_SS/RS
Open the gas cap and push the relief valve on the...

Open the gas cap and push the relief valve on the fuel rail
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-07-2019, 12:55 PM
Replies: 12
Views: 597
Posted By xc_SS/RS
Wait he actually made changes based on a...

Wait he actually made changes based on a datalog?! I tried a handful of times to get him to make changes to my tune and was always told 'no need, it's good to go!'. It wasn't tuned well.

Good for...
Forum: Tuning / Diagnostics -- engine and transmission 09-27-2019, 02:06 PM
Replies: 8
Views: 523
Posted By xc_SS/RS
AEM 30-0334. Comes with a canbus connector that...

AEM 30-0334. Comes with a canbus connector that will let HPTuners record the wideband readings. No messing with breakout harnesses. I only have 1 sensor, no real need for two unless you're running a...
Forum: Tuning / Diagnostics -- engine and transmission 09-27-2019, 01:58 PM
Replies: 3
Views: 278
Posted By xc_SS/RS
Post your config files from the scanner if you...

Post your config files from the scanner if you really want some help. We can't do anything without seeing what you are trying to record with...

Not trying to be an ass but from your post I have...
Forum: Tuning / Diagnostics -- engine and transmission 09-24-2019, 04:47 PM
Replies: 8
Views: 416
Posted By xc_SS/RS
I think you can set the pressures to 450 kpa and...

I think you can set the pressures to 450 kpa and it should increase (CTS-V regulator I think is 65psi or higher). I had to set normal and high flow to 450 kpa to get higher pressure with my new pump...
Forum: Tuning / Diagnostics -- engine and transmission 09-24-2019, 04:40 PM
Replies: 16
Views: 950
Posted By xc_SS/RS
Idle adaptive airflow needs adjusting and I would...

Idle adaptive airflow needs adjusting and I would imagine your final idle airflow will also need to be adjusted.

There's a big thread on how to idle tune on the HPTuners forum. Good read and...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-24-2019, 10:02 AM
Replies: 8
Views: 631
Posted By xc_SS/RS
You guys could always switch to the tall Holley...

You guys could always switch to the tall Holley valve covers
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-18-2019, 04:31 PM
Replies: 9
Views: 480
Posted By xc_SS/RS
Slave cylinder bearing support. Buy a new slave...

Slave cylinder bearing support. Buy a new slave cylinder, it'll come with the throw out bearing.

If you want there are companies that make a replacement support piece from aluminum
Forum: General Automotive + Other Cars Discussion 09-18-2019, 04:29 PM
Replies: 1
Views: 893
Posted By xc_SS/RS
CA emissions standards revoked

https://www.zerohedge.com/political/trump-revokes-californias-ability-set-fuel-emissions-standards

Wonder how this will affect car and aftermarket parts prices (no more CARB certs?).
Forum: General Automotive + Other Cars Discussion 09-08-2019, 09:00 AM
Replies: 14
Views: 2,010
Posted By xc_SS/RS
That's so weird. I understand people saying...

That's so weird. I understand people saying something for loud cars that are started too early during the week but dryer sheets is something else. Don't tell em about the new washer/dryer beads they...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-06-2019, 11:09 AM
Replies: 1,462
Views: 71,525
Posted By xc_SS/RS
I'd put the inlet on the front or rear of the...

I'd put the inlet on the front or rear of the passenger fuel rail and run a fuel line right to the hard line on the fender. I don't see any reason that you would want to run the fuel line on the...
Forum: General Automotive + Other Cars Discussion 09-05-2019, 03:07 PM
Replies: 14
Views: 2,010
Posted By xc_SS/RS
Why, what was their reasoning??

Why, what was their reasoning??
Forum: 5th Gen Camaro SS LS LT General Discussions 09-05-2019, 09:24 AM
Replies: 5
Views: 407
Posted By xc_SS/RS
If you're going to make your own take some...

If you're going to make your own take some pictures! I've wanted to make something for the middle of the car but not sure how or where to secure the pieces.

When I installed my belly pan it made...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-03-2019, 02:54 PM
Replies: 37
Views: 1,872
Posted By xc_SS/RS
What I'll do for my parents dog is try to make...

What I'll do for my parents dog is try to make the back seat level with extra towels so she doesn't sit funny. Then I'll cover the seat back/bottom with a blanket or towels. She will lay down and...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-03-2019, 09:31 AM
Replies: 3
Views: 215
Posted By xc_SS/RS
If you get the Morimoto fogs you'll like them....

If you get the Morimoto fogs you'll like them. They put out a ton of light
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-01-2019, 06:10 PM
Replies: 1,462
Views: 71,525
Posted By xc_SS/RS
Ahh nice that's good it drives smoothly. I think...

Ahh nice that's good it drives smoothly. I think I may upgrade from the Z/28 to a Pmas intake. 120mm MAF should flow well lol
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-30-2019, 10:03 AM
Replies: 63
Views: 3,708
Posted By xc_SS/RS
Still have this cam! Brand new, still in...

Still have this cam!

Brand new, still in it's bag!
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-25-2019, 02:30 PM
Replies: 11
Views: 850
Posted By xc_SS/RS
Sold! This can be closed

Sold! This can be closed
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-23-2019, 05:26 PM
Replies: 1,462
Views: 71,525
Posted By xc_SS/RS
I think a sd tune is smoother than a MAF only or...

I think a sd tune is smoother than a MAF only or blended tune. The problem with the MAF is if your airflow isn't smooth, your tune will not be very accurate
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-23-2019, 12:01 PM
Replies: 1,462
Views: 71,525
Posted By xc_SS/RS
Speed density will be easier to tune. The MAF...

Speed density will be easier to tune. The MAF could have issues being in that large of a pipe (stock is something like 96mm vs 114 for 4.5")

You'll love going e85 lol
Forum: 5th Gen Camaro SS LS LT General Discussions 08-22-2019, 08:40 PM
Replies: 17
Views: 1,428
Posted By xc_SS/RS
X2. Once the long bolt is cut the dash frame...

X2. Once the long bolt is cut the dash frame should come off without removing the windshield
Forum: General Automotive + Other Cars Discussion 08-22-2019, 11:57 AM
Replies: 6,776
Views: 925,703
Posted By xc_SS/RS
With front fog lights and blacked out headlights

With front fog lights and blacked out headlights
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 12:23 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2019, vBulletin Solutions, Inc.